Summary of EasyNote SB Series
Page 1
Packard bell easynote sb series disassembly guide.
Page 2: Table of Contents
Easynote sb disassembly manual 2 table of contents overview ..................................................................................................................3 technician notes......................................................................................................3 disa...
Page 3: Overview
Easynote sb disassembly manual 3 overview this document contains step-by-step disassembly instructions for the easynote sb series. The instructions are illustrated where necessary with images of the part of the device that is being removed or disassembled. Packard bell reserves the right to make cha...
Page 4: Battery
Easynote sb disassembly manual 4 battery 1. Push aside the 2 clips securing the battery. Fig. 1 removing the battery. 2. Pull out the battery hard disk 1. Remove the battery 2. Remove the screw securing the hard disk cover. 3. Remove the screws securing the main cover. Fig. 2 the bottom of the noteb...
Page 5
Easynote sb disassembly manual 5 fig. 3 the hdd compartment. 5. Remove the 2 screws of the hdd bracket and take away the bracket. Fig. 4 the hdd and its bracket. 6. Remove the screw on the right hand drive. 7. Pull the right hard disk to the right and lift it out..
Page 6: Optical Drive
Easynote sb disassembly manual 6 fig. 5 the hdd compartment.. 8. Remove the 2 screws of the hdd bracket and take away the bracket. Fig. 6 the hdd and its bracket. Note: the easynote sb series use s-ata hard disks. S-ata hard disks have no master/slave settings (so no jumpers needed). Optical drive 1...
Page 7
Easynote sb disassembly manual 7 fig. 7 the optical drive screws. 3. Use the emergency-eject to open the drive tray. Pull the drive out. Close the tray again. Fig. 8 removing the optical drive. 4. Remove the 2 brackets from the optical drive (1x 2 and 1x 1 screws)..
Page 8: Memory Modules
Easynote sb disassembly manual 8 fig. 9 the optical drive brackets. 5. Remove the bezel: push the 2 clips to push the bezel loose fig. 10 removing the optical drive bezel. Memory modules 1. Remove the battery. 2. Remove the screws for the large cover on the bottom of the unit. Fig. 11 the bottom bas...
Page 9: Wireless Lan Card
Easynote sb disassembly manual 9 4. The memory module(s) are located in the left of the compartment. To release the modules, push the metal clips aside. This will release the module. Fig. 12 removing the memory modules. 5. Lift the memory module out. Note: in case you have 2 memory modules installed...
Page 10
Easynote sb disassembly manual 10 fig. 13 the bottom base screws. Note: the screws stay attached to the cover. 3. Lift the door out. 4. The wireless lan adapter is located to the left side. Remove the two screws securing the card and lift the card up. Fig. 14 removing the wireless card. 5. Now disco...
Page 11: Tv-Card
Easynote sb disassembly manual 11 tv-card 1. Remove the battery. 2. Remove the screws of the cover on the bottom base (see fig 13). Note: the screws stay attached to the cover. 3. Lift the door out. 4. The tv-card is located to left. Remove the screws securing the card and lift it up. Fig. 15 the tv...
Page 12: Keyboard
Easynote sb disassembly manual 12 fig. 16 the heatsink. 8. Lift out the heatsink. 9. Turn the screw in the cpu socket 180 degrees. 10. Lift the cpu out. Note: the socket used on the easynote mb65, mb66, mb85 and mb86 resembles the cpu socket used for older celeron m, pentium m, core duo and core 2 d...
Page 13: Lcd Assembly
Easynote sb disassembly manual 13 fig. 18 the keyboard flatcable. 5. Lift out the keyboard. Lcd assembly 1. Remove the battery. 2. Disconnect the wlan antenna as described above. 3. Remove screw ‘ 3’ from the heatsink to loosen the grounding cable. 4. Disconnect the lcd cable. Fig. 19 the lcd cable..
Page 14: Lcd Panel
Easynote sb disassembly manual 14 5. Remove two screws located near the edges on the rear side bottom of the unit. 6. Remove the two screws from the rear side of the unit. Fig. 20 the bottom of the notebook. 7. Remove the 2 hinge covers. You can leverage them loose with a small flathead screwdriver....
Page 15
Easynote sb disassembly manual 15 fig. 21 the lcd panel. 4. Remove the lcd bezel; it is clicked in place. 5. Disconnect both cables from the inverterboard, and the cable connected to the webcam. 6. Lift out the lcd panel. 7. Remove the 6 screws (3 at each side) to remove the lcd brackets. Fig. 22 th...
Page 16: Webcam
Easynote sb disassembly manual 16 webcam 1. Remove the lcd assembly as described above 2. Remove lcd bezel as described above. 3. Disconnect the cable from the webcam. Fig. 23 the webcam. 4. Remove the 2 screws from the webcam module. 5. Lift out the webcam module. Inverterboard 1. Remove the lcd as...
Page 17: Top Cover
Easynote sb disassembly manual 17 2. Peel the optional 3rd antenna loose; it is glued to the metallic foil. Fig. 25 the lcd back panel. 3. Release the antenna from the metallic foil. Top cover 1. Remove the battery, hard disk, optical drive, memory modules, wireless lan, tv-card or intel turbo memor...
Page 18: Mainboard
Easynote sb disassembly manual 18 3. Remove the 2 screws from the top cover. Fig. 27 the keyboard area. 4. Disconnect the three cables accessible from the top cover. 5. Remove the top cover. Mainboard 1. Remove the top cover, as described above. 2. Remove the 2 hex-bolts adjacent to the dvi-i connec...
Page 19: Bluetooth Module
Easynote sb disassembly manual 19 4. Remove the 6 screws marked with a screw-sign on the mainboard. Fig. 29 the screw-sign icon. Bluetooth module 1. Remove the top cover as described above. 2. Disconnect the bluetooth cable from the bluetooth module. Fig. 30 the bluetooth cable. 3. Take out the blue...
Page 20: Dc Jack
Easynote sb disassembly manual 20 fig. 31 the audio board. Dc jack 1. Remove the top cover as described above. 2. Disconnect the dc jack connector from the mainboard..
Page 21: Modem Connector
Easynote sb disassembly manual 21 fig. 32 the dc jack connector. 3. Remove the metal shield covering the dc jack and modem connector. Fig. 33 the small metal shield. 4. Lift the dc jack from its bracket. Modem connector 1. Remove the mainboard as described as above. 2. Remove the metal shield coveri...
Page 22: Speakers and Subwoofer
Easynote sb disassembly manual 22 speakers and subwoofer the speakers and subwoofer are shipped as part of the bottom base and do not require further disassembly. Button and led board and touchpad the button/led board and touchpad are shipped as part of the top cover and do not require further disas...
Page 23: Reassembly Notes
Easynote sb disassembly manual 23 reassembly notes when reassembling the device, please take notice of the order in which the parts can be put back and reattached. Notice the information in this guide is subject to change without notice. This guide contains information protected by copyright. No par...