Summary of EasyNote SJ
Page 1
Packard bell easynote sj disassembly manual.
Page 2: Table of Contents
11111 packard bell easynote sj disassembly manual 1 table of contents overview............................................................................................................................................... 2 technician notes ..............................................................
Page 3: Overview
Packard bell easynote sj disassembly manual 2 overview this document contains step-by-step disassembly instructions for the packard bell easynote sj. The instructions are illustrated where necessary with images of the part that is being removed or disassembled. Packard bell reserves the right to mak...
Page 4: Hazardous Voltage
Packard bell easynote sj disassembly manual 3 hazardous voltage there is hazardous voltage present inside the notebook when it is connected to an ac supply, even when the notebook’s power switch is off. Exposure to hazardous voltage could cause personal injury. To avoid risk of injury, contact an au...
Page 5: Battery
44444 packard bell easynote sj disassembly manual 4 battery perform the following steps to remove the battery: 1. Make sure the power is off. 2. Turn the notebook upside down. Note: use an anti-static mat or something soft like a piece of cloth underneath the notebook to prevent damage to the exteri...
Page 6
55555 packard bell easynote sj disassembly manual 5 fig. 3 disconnecting and removing hard disk drive(s). 3. Take the drive out of its compartment as shown in fig. 3 . 4. Remove the 2 screws on the metal bracket to separate it from the hard disk drive. Fig. 4 location of hard disk drive bracket scre...
Page 7: Memory
66666 packard bell easynote sj disassembly manual 6 note: if the system ships with 2 hard drives, they will be configured as 2 separate drives and not in any type of raid configuration. Memory to remove the memory installed, first remove the battery (see battery ) and then perform the following step...
Page 8: Wireless Lan Adapter
77777 packard bell easynote sj disassembly manual 7 wireless lan adapter to remove the wireless lan adapter, first remove the battery (see battery ) and then perform the following steps: 1. Remove the 7 screws retaining the memory/cpu/wlan cover ( see fig. 5 ). 2. Carefully disconnect the 2 wireless...
Page 9
88888 packard bell easynote sj disassembly manual 8 fig. 8 location of cpu fan screws. 3. Disconnect the power cable and remove the cpu fan (see fig. 8 ). 4. Turn the 6 screws securing the heat sink halfway loose in designated order. Fig. 9 location of heat sink screws. 5. Now remove the 6 screws, a...
Page 10: Keyboard
99999 packard bell easynote sj disassembly manual 9 fig. 10 removing cpu. 8. Take out the cpu. Keyboard to remove the keyboard, first remove the battery (see battery ) and then perform the following steps: 1. Turn the notebook over so the top is facing up and open the lcd completely. 2. Release the ...
Page 11: Optical Disk Drive
1010101010 packard bell easynote sj disassembly manual 10 fig. 12 location of keyboard screws. 5. Tilt the keyboard gently forward (see fig. 12 ). 6. Before removing the keyboard entirely, carefully release the clip securing the flat cable and disconnect the cable from the main board. Fig. 13 discon...
Page 12: Button Board
1111111111 packard bell easynote sj disassembly manual 11 fig. 15 releasing tray cover (side). 6. Next release the tray cover on the bottom of the drive. Fig. 16 releasing tray cover (bottom). 7. Remove the cover and close the tray! Button board the button board contains the power button, the eco an...
Page 13: Top Cover
1212121212 packard bell easynote sj disassembly manual 12 fig. 17 location button board screws. 2. Carefully disconnect the flat cable from the main board (see fig. 17 ). 3. Lift out the button board. 4. Disconnect the flat cable from the button board. Fig. 18 disconnecting flat cable. Top cover to ...
Page 14
1313131313 packard bell easynote sj disassembly manual 13 fig. 19 location of speaker cables connector. 2. Disconnect the standby-switch cable. Fig. 20 disconnecting standby-switch cable. 3. Disconnect the touchpad cable. Fig. 21 disconnecting touchpad cable..
Page 15: Hdd Board
1414141414 packard bell easynote sj disassembly manual 14 4. Disconnect the button board flat cable (see fig. 17 ). 5. Remove the 7 screws securing the cover. Fig. 22 location of top cover screws. 6. Turn the notebook upside down. 7. Remove the 13 screws (all m2.5x6). Fig. 23 location of top cover s...
Page 16: Odd Board
1515151515 packard bell easynote sj disassembly manual 15 1. Remove the 2 screws securing the hdd board. Fig. 24 location of hdd board screws. 2. Lift out the hdd board (it has been clicked onto the main board). Odd board the odd board extends the ide connector for the optical drive from the main bo...
Page 17: Speakers
1616161616 packard bell easynote sj disassembly manual 16 speakers to remove the speakers, first remove the top cover (see top cover ), and then perform the following steps: 1. Remove the screws securing each speaker. Fig. 26 location of speaker screws. 2. Release the speaker cables from the clips a...
Page 18: Touchpad Button Board
1717171717 packard bell easynote sj disassembly manual 17 2. Remove the 2 screws securing the subwoofer and lift it out (see fig. 27-b ). Note: the subwoofer is optional. Touchpad button board the touchpad button board is located on the top cover. To remove it, first remove the top cover (see top co...
Page 19: Modem Board
1818181818 packard bell easynote sj disassembly manual 18 fig. 29 location of standby switch screw. 2. Clear the cable and remove the standby switch. Modem board to remove the modem board, first remove the top cover (see top cover ), and then perform the following steps: 1. Remove the 2 screws secur...
Page 20: Bluetooth Module
1919191919 packard bell easynote sj disassembly manual 19 1. Disconnect the modem cable from the main board (see fig. 30-b ). 2. Remove the screw securing the rj11 connector bracket. Fig. 31 location of rj11 connector bracket screw. 3. Take out the rj11 connector and cable. Fig. 32 removing rj11 con...
Page 21: Bluetooth Antenna
2020202020 packard bell easynote sj disassembly manual 20 fig. 33 disconnect bluetooth antenna and cable. 2. Remove the screw securing the bluetooth module. Fig. 34 location of bluetooth module screw. 3. Remove the bluetooth module. Note: bluetooth is optional. Bluetooth antenna to remove the blueto...
Page 22: Main Board
2121212121 packard bell easynote sj disassembly manual 21 fig. 35 removing bluetooth antenna. Note: bluetooth is optional. Main board to remove the main board, remove the cpu and the cpu fan (see cpu and cpu fan ), remove the memory (see memory ), remove the wireless lan adapter (see wireless lan ad...
Page 23: Lcd Panel Assembly
2222222222 packard bell easynote sj disassembly manual 22 6. Disconnect the rtc battery cable and remove the rtc battery; it has been glued onto place. Fig. 37 location of rtc battery. Lcd panel assembly to disassembly the lcd panel assembly, first remove the keyboard (see keyboard ), remove the cpu...
Page 24: Lcd Bezel
2323232323 packard bell easynote sj disassembly manual 23 fig. 39 location of screws on back panel. 5. Remove 2 screws from the bottom of the notebook. Fig. 40 location of screws. 5. Open the lcd panel to a 90-degree angle and lift out the lcd panel assembly. Lcd bezel to remove the lcd bezel, first...
Page 25: Lcd Panel
2424242424 packard bell easynote sj disassembly manual 24 lcd panel to remove the lcd panel, first remove the lcd bezel (see lcd bezel ), and then do the following: 1. Remove the 4 screws from the hinges. Fig. 42 location of screws securing hinges. 2. Disconnect both cables from the inverter board. ...
Page 26: Inverter Board
2525252525 packard bell easynote sj disassembly manual 25 fig. 44 removing grounding cable screw. 4. Lift out the panel. 5. Remove the 4 screws on each side securing the brackets for the panel. Fig. 45 location of screw securing brackets. 6. Push the clips to disconnect the lcd cable from the back o...
Page 27: Wlan Antenna
2626262626 packard bell easynote sj disassembly manual 26 fig. 46 location of webcam connector. 2. Lift out the webcam; it may be glued and/or taped onto place. Note: you have to remove the lcd panel if the webcam cable needs to be replaced. Wlan antenna to remove the wireless antenna, first remove ...
Page 28: Notice
2727272727 packard bell easynote sj disassembly manual 27 notice the information in this guide is subject to change without notice. This guide contains information protected by copyright. No part of this guide may be photocopied or reproduced in any form or by any means without prior written consent...