Summary of EasyNote ST
Page 1
Packard bell easynote st disassembly manual.
Page 2: Table of Contents
11111 packard bell easynote st disassembly manual 1 table of contents about this guide .....................................................................................................................2 for more information ............................................................................
Page 3: About This Guide
Packard bell easynote st disassembly manual 2 about this guide this guide contains systematic disassembly instructions for the packard bell easynote st. The instructions are illustrated where necessary with images of the part that is being disassembled. Packard bell b.V. Reserves the right to make c...
Page 4: Hazardous Voltage
Packard bell easynote st disassembly manual 3 hazardous voltage there is hazardous voltage present inside the notebook when it is connected to an ac supply, even when the notebook’s power switch is off. Exposure to hazardous voltage could cause personal injury. To avoid risk of injury, contact an au...
Page 5: Battery
44444 packard bell easynote st disassembly manual 4 battery perform the following steps to remove the battery: 1. Make sure the power is off. 2. Turn the notebook upside down. Note: use an anti-static mat or something soft like a piece of cloth underneath the notebook to prevent damage to the exteri...
Page 6: Memory
55555 packard bell easynote st disassembly manual 5 2. Lift the cover upwards from the back. There are four tabs holding the cover in place on the front. Raise the cover until you can remove it from the casing (see fig. 2 on page 4). 3. Pull the plastic tab on the hard disk drives towards the left t...
Page 7: Wireless Lan Adapter
66666 packard bell easynote st disassembly manual 6 3. Release the clip on each side securing the memory module; the module will eject upwards. Fig. 5 removing memory module. 4. Carefully remove the memory module from the socket. Note: in case two memory modules have been installed, you have to remo...
Page 8: Tv Tuner (Optional)
77777 packard bell easynote st disassembly manual 7 note: there are two wifi antenna cables connected to the wireless lan adapter. The black wifi antenna cable is connected to main (1) connector and the white wifi antenna cable is connected to aux (2) connector. 4. Remove the screw securing the wire...
Page 9: Optical Disk Drive
88888 packard bell easynote st disassembly manual 8 intel turbo memory (optional) to remove the optional intel turbo memory module (mini pci express), first remove the battery (see battery on page 4), and then perform the following steps: 1. Remove the two screws securing the memory compartment cove...
Page 10: Keyboard
99999 packard bell easynote st disassembly manual 9 5. Insert the flat screwdriver into the notch at the underside of the tray to release the tray bezel lock. Fig. 10 location tray bezel lock underside. 6. Insert the small flat screwdriver into the notch at the side of the tray to release the side l...
Page 11: Keyboard Cover
1010101010 packard bell easynote st disassembly manual 10 2. Release the keyboard by prying it up along the top side of the keyboard. There are five tabs holding the keyboard in place on the front, particularly at the following keys: , , , and . Fig. 12 removing keyboard. 3. Tilt the keyboard gently...
Page 12: Top Cover
1111111111 packard bell easynote st disassembly manual 11 1. Remove the nine screws securing the keyboard cover. Note that three screws are located in the battery compartment. Fig. 14 location keyboard cover screws. 2. Turn the notebook over so the top is facing up and open the lcd completely. 3. Re...
Page 13
1212121212 packard bell easynote st disassembly manual 12 3. Turn the notebook over so the top is facing up and remove the five screws securing the top cover. Fig. 17 location of cover screws in keyboard compartment. Note: the screw nearest to the optical drive is shorter than the other four. 4. Rem...
Page 14: Lcd Assembly
1313131313 packard bell easynote st disassembly manual 13 6. Release the white clip securing the button board flat cable and disconnect the cable. Fig. 20 disconnecting button board flat cable. 7. Remove the top cover. Lcd assembly to disassemble the lcd assembly, first disconnect the wifi antenna c...
Page 15: Speakers
1414141414 packard bell easynote st disassembly manual 14 4. Remove the screws securing the hinges. Fig. 22 location lcd hinge screws. 5. Lift out the lcd assembly. Speakers to remove the speakers, first remove the top cover (see top cover on page 11), and then perform the following steps: 1. Remove...
Page 16: Main Board
1515151515 packard bell easynote st disassembly manual 15 3. Disconnect the speaker cables from the header on the main board. Fig. 24 location of speaker cable header on the main board. Note: the left and right speaker assembly share the same header on the main board. Main board to remove the main b...
Page 17
1616161616 packard bell easynote st disassembly manual 16 2. Carefully disconnect the power cable from the header on the main board. Fig. 26 location of cooler cable and screws. 3. Remove the two screws securing the cooler (see fig. 26 on page 16). 4. Remove the dc jack cable from the header on the ...
Page 18
1717171717 packard bell easynote st disassembly manual 17 5. Disconnect the optional bluetooth cable from the header on the main board. Fig. 28 disconnecting optional bluetooth cable. 6. Release the white clip securing the usb board cable and disconnect the audio board cable from the headers on the ...
Page 19: Cpu and Heat Sink
1818181818 packard bell easynote st disassembly manual 18 9. Before removing the main board entirely, carefully release the white clip securing the ethernet/usb board flat cable and disconnect the cable from the main board. Fig. 30 location of ethernet/usb flat cable. 10. Lift the main board out of ...
Page 20: Cmos Battery
1919191919 packard bell easynote st disassembly manual 19 4. Turn the screw in the cpu into the unlock position to release the cpu. Fig. 32 location of screw securing cpu. 5. Carefully take out the cpu from the socket. Cmos battery to remove the cmos battery, first remove the main board (see main bo...
Page 21: Bluetooth (Optional)
2020202020 packard bell easynote st disassembly manual 20 bluetooth (optional) to remove the optional bluetooth module, first remove the top cover (see top cover on page 11), and then perform the following steps: 1. Disconnect the bluetooth cable from the header on the main board (see fig. 28 on pag...
Page 22
2121212121 packard bell easynote st disassembly manual 21 1. Remove the screw securing the bracket that holds the right speaker and take out the bracket. Fig. 35 location of right speaker bracket screw. 2. Remove the subwoofer cable from the ethernet/usb board. Fig. 36 location of screws securing et...
Page 23: Subwoofer
2222222222 packard bell easynote st disassembly manual 22 3. Remove the three screws securing the ethernet/usb board (see fig. 36 on page 21). 4. Carefully tilt the ethernet/usb board from the back. 5. Before removing the board entirely, carefully release the white clip securing the ethernet/usb boa...
Page 24: Dc Jack
2323232323 packard bell easynote st disassembly manual 23 1. Remove the three screws securing the subwoofer. Fig. 38 location subwoofer screws. Note: on fig. 38 , one of the screws is partly covered by the dc jack cable. 2. Take out the subwoofer. Dc jack to remove the dc jack, first remove the ethe...
Page 25: Tv Antenna (Optional)
2424242424 packard bell easynote st disassembly manual 24 2. Remove the two screws securing the dc jack. Fig. 39 disconnecting dc jack. 3. Take out the dc jack. Tv antenna (optional) to remove the optional tv antenna cable, first remove the ethernet/usb board (see ethernet/usb board on page 20), and...
Page 26: Touchpad
2525252525 packard bell easynote st disassembly manual 25 2. Remove the two screws securing the tv antenna connector. Fig. 40 location of tv antenna connector. 3. Clear the cable and take out the tv antenna. Touchpad to remove the touchpad module, first remove the top cover (see top cover on page 11...
Page 27: Button Board
2626262626 packard bell easynote st disassembly manual 26 button board to remove the button board, first remove the top cover (see top cover on page 11), and then perform the following steps: 1. Remove the three screws securing the button board. Fig. 42 location of button board screws. 2. Remove the...
Page 28: Lcd Panel
2727272727 packard bell easynote st disassembly manual 27 lcd panel to disassembly the lcd panel, first remove the lcd assembly (see lcd assembly on page 13), remove the lcd bezel (see lcd bezel on page 26), and then perform the following steps: 1. Remove the screw to release the grounding cable. Fi...
Page 29: Webcam/microphone
2828282828 packard bell easynote st disassembly manual 28 5. Disconnect the lcd cable. Fig. 46 location of lcd cable connector. 6. Remove the side brackets (four screws on each side). Webcam/microphone to remove the webcam and microphone, first remove the lcd panel (see lcd panel on page 27), and th...
Page 30: Notice
2929292929 packard bell easynote st disassembly manual 29 notice the information in this guide is subject to change without notice. This guide contains information protected by copyright. No part of this guide may be photocopied or reproduced in any form or by any means without prior written consent...