Packard Bell FPS-100 User Instructions

Summary of FPS-100

  • Page 1

    Fps-100 a d i v i s i o n o f n e c c o m p u t e r s i n t e r n a t i o n a l user instructions packard bell fps-100v2.Qxd 05/12/2002 16:04 page 1.

  • Page 2: Arnings

    Z z do read the operating instructions before you attempt to use the equipment. Z z do ensure that all electrical connections (including the mains plug, extension leads and inter-connections between the pieces of equipment) are properly made and in accordance with the manufacturers instructions. Z z...

  • Page 3

    Plug the line in connector into the line out socket of your audio source. 2 3 4 make sure the power switch on the speakers is switched off, then plug the subwoofer into the mains. Plug the speaker stereo jack from the satellite speakers into the line out socket of the subwoofer. 1 volume bass on off...

  • Page 4: 0870 9090444

    Total output power 12w rms satellites 3w rms per channel subwoofer 6w rms per channel drivers 4” subwoofer, slab tm flat panel satellites impedance 4 ohms signal to noise ratio 55db frequency response 70hz - 18khz 0870 9090444 all calls charged at national rate partmaster accessories and spares serv...