Summary of Vibe 100
Page 1
Packard bell vibe 100 disassembly manual.
Page 2: Table of Contents
1 packard bell vibe 100 disassembly manual table of contents overview 2 technician notes 2 disassembly instructions 2 reassembly instructions 2 required tools 2 hazardous voltage 3 avoid electrostatic discharge 3 power supply unit 3 opening the casing 5 removing the battery 5 removing the hard disk ...
Page 3: Overview
2 packard bell vibe 100 disassembly manual overview this document contains step-by-step disassembly instructions for the vibe 100 mp3 player. The instructions are illustrated where necessary with images of the part that is being removed or disassembled. Furthermore, the screws that are removed are s...
Page 4: Hazardous Voltage
3 packard bell vibe 100 disassembly manual hazardous voltage there is hazardous voltage present inside the mp3 player when it is connected to an ac supply, even when the mp3 player’ s power switch is off. Exposure to hazardous voltage could cause personal injury. To avoid risk of injury, contact an ...
Page 5
Packard bell vibe 100 disassembly manual 4 mp3 mientras la cubierta esté quitada. Waarschuwing zorg er voor dat alle verbindingen van en naar de mp3 speler (stroom, modem, netwerk, etc) verbroken worden voordat de behuizing geopend wordt. Zet de mp3 speler nooit aan als de behuizing geopend is. Avve...
Page 6: Opening The Casing
5 packard bell vibe 100 disassembly manual opening the casing to open the player, perform these following steps: 1. Gently pry the bottom and the top cover apart. There is a flat cable keeping the mainboard and the hard disk together. Fig. 1 location of the flat cable 2. Disconnect the flat cable on...
Page 7: Removing The Hard Disk
Packard bell vibe 100 disassembly manual 6 fig. 2 location of the battery connector 4. Release the connector on the mainboard. Use a small flathead screwdriver or tweezers. 5. Disconnect the battery from the mainboard. Removing the hard disk to remove the top cover, open the player (see opening the ...
Page 8
Packard bell vibe 100 disassembly manual 7 2. Disconnect the flat cable from the hard disk. To do so, lift up the dark-coloured clip and pull out the flat cable. Fig. 4 the flat cable connector 3. Remove the rubber placeholders, and place them on the new hard disk. 4. Reconnect the flat cable: push ...
Page 9
Packard bell vibe 100 disassembly manual 8 fig. 5 the hdd connector. 5. Push the side panel of the top cover gently aside. 6. The mainboard is loose now but the lcd panel is glued to the front. When removing the mainboard, the lcd screen itself will hinge. Carefully tear it loose. 7. When re-inserti...
Page 10
Packard bell vibe 100 disassembly manual 9 9. Make sure the hold switch is properly aligned (see fig. 7 ) fig. 7 the hold switch.
Page 11: Notice
10 packard bell vibe 100 disassembly manual notice the information in this guide is subject to change. This guide contains information protected by copyright. No part of this guide may be photocopied or reproduced in any form or by any means without prior written consent from nec computers internati...