Summary of Vibe 300
Page 1
Packard bell vibe 300 disassembly manual.
Page 2: Table of Contents
1 packard bell vibe 300 disassembly manual table of contents overview 2 technician notes 2 disassembly instructions 2 reassembly instructions 2 required tools 2 removing the bottom cover 3 removing the hdd 4 removing the battery 4 removing the main board / lcd panel 5 removing the keypad 7 reassembl...
Page 3: Overview
2 packard bell vibe 300 disassembly manual overview this document contains step-by-step disassembly instructions for the vibe 300 mp3 player. The instructions are illustrated where necessary with images of the part that is being removed or disassembled. Packard bell reserves the right to make change...
Page 4: Removing The Bottom Cover
3 packard bell vibe 300 disassembly manual removing the bottom cover 1. Remove three rubber stoppers (you do not need to remove the stopper located on the fm module cover.) fig. 1 removing the rubber stoppers. 2. Remove the fm module cover. It has been clicked into place, so you can easily push it o...
Page 5: Removing The Hdd
Packard bell vibe 300 disassembly manual 4 fig. 3 vibe 300 without bottom cover. Removing the hdd to remove the hdd, first remove the bottom cover (see section removing the bottom cover ) and then follow the steps below: 1. Disconnect micro drive (pull drive while holding the flat cable). You can pu...
Page 6
Packard bell vibe 300 disassembly manual 5 fig. 5 disconnecting the battery from the main board. Removing the main board / lcd panel to remove the main board / lcd panel, first remove the bottom cover (see section removing the bottom cover ), remove the hdd (see section removing the hdd ) and remove...
Page 7
Packard bell vibe 300 disassembly manual 6 fig. 7 disconnecting the keypad flat cable. 4. Separate the top cover and main board. 5. In case you need to replace the main board, disconnect the hdd flat cable: push the two clips in the indicated direction (see fig 8 ) and take out the flat cable. Fig. ...
Page 8: Removing The Keypad
Packard bell vibe 300 disassembly manual 7 7. Lift the lcd panel from the main board. The backside might be “glued”, so you might need to apply some force. Fig. 10 removing lcd panel from main board. Removing the keypad to remove the keypad, first remove the bottom cover (see section removing the bo...
Page 9
Packard bell vibe 300 disassembly manual 8 button! The switch on the main board fits exactly in the plastic switch located in the side panel. Fig. 12 power button. N the rubber stoppers are keyed, so they only fit properly in one way. Fig. 13 keyed rubber stopper. N the micro drive is not keyed and,...
Page 10: Notice
9 packard bell vibe 300 disassembly manual notice the information in this guide is subject to change without notice. This guide contains information protected by copyright. No part of this guide may be photocopied or reproduced in any form or by any means without prior written consent from nec compu...