Summary of Vibe 500
Page 1
Packard bell vibe 500 disassembly manual.
Page 2: Table of Contents
1 packard bell vibe 500 disassembly manual table of contents overview 2 technician notes 2 disassembly instructions 2 reassembly instructions 2 required tools 2 hazardous voltage 3 avoid electrostatic discharge 3 power supply unit 3 opening the casing 4 removing the battery 5 removing the top cover ...
Page 3: Overview
2 packard bell vibe 500 disassembly manual overview this document contains step-by-step disassembly instructions for the vibe 500 mp3 player. The instructions are illustrated where necessary with images of the part that is being removed or disassembled. Furthermore, the screws that are removed are s...
Page 4: Hazardous Voltage
3 packard bell vibe 500 disassembly manual hazardous voltage there is hazardous voltage present inside the mp3 player when it is connected to an ac supply, even when the mp3 player’ s power switch is off. Exposure to hazardous voltage could cause personal injury. To avoid risk of injury, contact an ...
Page 5: Opening The Casing
4 packard bell vibe 500 disassembly manual opening the casing to open the player, perform the following steps: 1. Remove the 2 screws in the side panels (one on each side). Fig. 1 location of screws on side panel. 2. Insert a coin (or use a small flat-bladed screwdriver) into the notch on the bottom...
Page 6: Removing The Battery
Packard bell vibe 500 disassembly manual 5 removing the battery to remove the internal battery, first open the casing (see opening the casing ) and then perform the following steps: 1. Disconnect the battery power cable from the main board fig. 4 disconnecting the battery power cable from the main b...
Page 7: Removing The Main Board
Packard bell vibe 500 disassembly manual 6 fig. 6 location lcd panel flat cable connector. 2. The lcd panel is glued to the metal bracket; use some force to separate the lcd panel from the main board. Removing the main board to remove the main board, open the player (see opening the casing ), remove...
Page 8
Packard bell vibe 500 disassembly manual 7 fig. 8 seperating the main board from the casing. 4. Disconnect the flat cable of the hard disk drive: carefully lift the white clip and pull out the flat cable. Fig. 9 hdd flat cable connector. Note keep in mind that the clip might be covered by the black ...
Page 9: Removing The Button Panel
Packard bell vibe 500 disassembly manual 8 2. Disconnect the flat cable from the hard disk drive: lift the white clip and pull out the cable. 3. Remove the 4 screws in the hard disk drive bracket (two on either side of the bracket). 4. Fold away the adhesive metal insulator. Fig. 11 adhesive metal i...
Page 10: Servicing The Touchpad
Packard bell vibe 500 disassembly manual 9 1. Remove the 2 screws in the metal bracket. Fig. 12 location of screws in the metal bracket. 2. Pull up the metal and lift it from the bottom clip. Note the button panel only contains the and buttons. All other buttons and the scrollbar are integrated in t...
Page 11: Notice
10 packard bell vibe 500 disassembly manual notice the information in this guide is subject to change. This guide contains information protected by copyright. No part of this guide may be photocopied or reproduced in any form or by any means without prior written consent from nec computers internati...