Pacvac Superpro 700 Product & Training Manual - page 5
www.pacvac.com
Support: 08 9479 1444
6
7
Wear Right
Step 1:
• Rotate the dome lid to suit left or right handed vacuuming.
• Loosen the shoulder straps.
• Adjust the length at top of shoulder strap (if required).
• Lift the back pack by one shoulder strap.
• Then slide your free arm into the other strap.
Step 2:
• Tighten the hipband so the machine rests
comfortably on your hips.
Step 3:
• Pull down on shoulder straps for a comfortable fit.
• Do up chest strap to secure back pack.
Step 4:
• Make sure the harness is resting on your hips.
IMPORTanT TIP:
If the back pack feels heavy or uncomfortable, it is
likely you are not wearing it correctly. Contact Pacvac
for further advice.
Work Right
lOOk aT THE layOuT (refer to the fishbone Method below)
• Find the most easily located power point. This is your starting location at the fish’s head.
Your turnaround is the ‘tail’.
• Check the room layout (position of desks, tables, chairs, fittings etc.)
• Check the condition of the floor - how dirty it is on a scale of 1 to 10.
Plan THE PROCESS
• See in your mind the fishbone method over the entire area or room to be cleaned.
• Decide which areas are to be detail cleaned (the spine), or spot cleaned (the ribs).
ClEan SMaRTER
• Work away from the power point.
• Work one side of the fishbone towards tail. Then back the other side towards head.
• Work to the plan - long strokes for the detail clean area and short dabs for the spot cleans.
1
2
3
fishhead Start
Spine Heavy Traffic Areas - Detail Clean
Ribs Light Traffic - Spot Clean