PAG PAG Quasar Instruction Manual
U5047A PAG QUASAR INSTRUCTION MANUAL
U5047A PAG QUASAR INSTRUCTION MANUAL
Instruction Manual
CONTENTS
SECTION
PAGE
1
SAFETY
2
2
SPECIFICATION
3
3
INSTALLATION
6
4
OPERATING INSTRUCTIONS
7
5
SERVICING & REPAIRS
12
6
WARRANTY
14
PAG Quasar
All-Chemistry Charging System
SAFETY
SECTION 1
1.1
This manual contains important safety and operating instructions.
Please read these fully and note all warnings before using the charger.
Please follow all instructions and retain this manual for future
reference.
1.2
PAG Quasar chargers are not intended for any use other than the
charging of batteries and the powering of broadcast cameras as
detailed in Section 2 , Specification, Page 3.
1.3
IMPORTANT: Use only on AC supplies 100V-250V, 47-63Hz or with
PAG approved voltage converters. Connection of the supply to the
unit should be made using only the standard lead provided with this
equipment.
1.4
Protect the power cord from being walked on or pinched. Unplug this
apparatus during lightning storms or when unused for long periods of
time.
1.5
Ensure that the ventilation slots are not obstructed when in use, e.g.
do not site the charger on a carpet, or cover when in use.
1.6
WARNING: Indoor use only. To reduce the risk of fire or electric
shock, do not expose this apparatus to rain or moisture.
1.7
Although the charger is reverse polarity and short circuit protected,
extreme care should always be taken not to short circuit the battery
itself. Rechargeable batteries can deliver power at a very high rate,
and short circuiting even a partially charged battery could result in a
fire or personal injury. PAG supplies a range of connector leads for
most charging requirements, and does not accept responsibility for
any other form of charging connection.
1.8
Do not disassemble the charger. There are no user-serviceable parts
inside. Incorrect re-assembly may result in a safety hazard.
1.9
Double Insulation: When servicing use only identical replacement parts.
1
2