Summary of pagbelt
Page 1
Instruction manual pagbelt ni-cd battery belt.
Page 2
1. Integral charger/cut-out pocket. 2. Deep moulded one piece leather case. 3. Twin output sockets. 4. Quick release buckle. 5. Shoulder harness attaching rings. 6. Charging/mains led (ic2 version only). 7. Waist strap. 8. Over discharge and thermal protection reset button. 9. Mains input socket (ic...
Page 3: Contents
Contents section page 1 specification 2 2 care and maintenance 4 3 instructions for use 5 4 safety 7 5 warranty 9 pagbelt ni-cd battery belt instruction manual.
Page 4: Section 1
2 specification section 1 1.1 pagbelt range: pagbelt ic2 incorporates an integral overnight charger. The model numbers of the ic2 and s2 ranges are identifiable from the following table: 5ah 7ah 10ah 12.0v s2 9187 9192 8 9197* ic2 9287 9292 8 9297* 13.2v s2 9188 9193 8 9198* ic2 9288 9293 8 9298* 14...
Page 5
3 1.6 thermal protection: the output sockets become isolated if cell temperature exceeds 70°c and can be reset when the temperature falls by pressing the odp reset button. 1.7 short circuit protection: the battery belt is protected against short circuit and excessive currents by means of a self-rese...
Page 6: Section 2
4 care & maintenance section 2 1.16 charger output voltage: 40v dc maximum. 1.17 output current: 5ah models: 500ma. 7ah models 700ma. 10ah models 1000ma. 1.18 charging indicator: indicator is lit when integral charger is operating. 1.19 safety: designed to comply with electrical safety standard bs e...
Page 7: Section 3
5 3.1 operation of the odp circuit. Nickel-cadmium batteries should not be discharged too deeply. If the voltage of a battery pack falls below 75% of its nominal voltage (e.G. 9v for a 12v battery) cells may be damaged by voltage reversal, thus shortening the life of the battery. To guard against th...
Page 8
6 belt has reached its maximum discharge state. See section 2.5 for the table of odp trip voltages. Additional to the above, the output sockets will also become isolated if the cell temperature exceeds 70°c. A single button is provided to reset these circuits and it is marked odp reset. If a battery...
Page 9: Section 4
7 the integral charger will correctly charge the battery belt in 12 - 14 hours to full capacity from a fully discharged state. No damage or gain will result if the belt is left on charge using the integral charger for an extended period beyond which the battery has become fully charged. 3.4 fast cha...
Page 10
8 4.2 general: do not put in fire or mutilate - cells may burst or release toxic material.Do not short circuit cells as this may cause burns. 4.3 corrosive electrolyte: the electrolyte is a mixture of potassium hydroxide (koh) and water. This can cause chemical burns to human tissue. Should leakage ...
Page 11: Section 5
9 section 5 5.1 notwithstanding any provision of any agreement the following warranty is exclusive: pag limited warrants each pagbelt it manufactures to be free of defects in material and workmanship under use and service for 18 months (2 years for the integral charger) from the date of purchase. Th...
Page 12
U4919 iss c / oct 03 t +44 (0)20 8543 3131 f +44 (0)20 8540 4116 e sales@paguk.Com www.Paguk.Com pag ltd. 565 kingston road raynes park london sw20 8sa.