Painless Performance 50001 Installation Instructions Manual - page 5
5.3 RELAY PLACEMENT See Figure 5.2.
6.0 CONNECTING 50001 TO 50201/50202
10-CIRCUIT SWITCH PANEL
6.1 CONTENTS OF THE SWITCH PANEL KIT
Take inventory to see that you have everything you're supposed to have in this kit. If anything is missing, go to the
dealer where you obtained the kit or contact Perfect Performance Products, Inc. at (817) 244-6898. The
50201/50202 Switch Panel Kit should contain the following items:
The 50201 Switch Panel (to be mounted in-dash) or the 50202 Switch Box (for roll bar mounting).
4 mounting screws
2 (12-pin) connector housings: 1 male (plug) and 1 female (jack)
15 mating female electrical contacts for the connectors. The male contacts are pre-installed.
1 grommet (50202 ONLY)
3 cap plugs (50202 ONLY) to fill unused holes.
Race Car Wire Harness Installation Instructions P/N 90502 (This booklet)
6.2 INSTALLATION AND CONNECTIONS (Refer to Figure 6.1, Table 6.1 and 6.2)
If you have not already done so, read Sections 4.0 of these instructions and think through the installation of the
harness kit before securing or cutting any wires.
Figure 6.1 Proper method of
terminal insertion into connectors.
Figure 5.2 50001 Relay and Fuse Placement