Ke-5t, ke-5tb, ke-8t, ke-9tb, ke-17tb plastic-palm 10base-t ethernet hub user’s guide.
Fcc warning this equipment has been tested and found to comply with the regulations for a class a digital device, pursuant to part 15 of the fcc rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. ...
Table of contents introduction............................................................................1 p roduct f eatures .....................................................................1 t he f ront p anel of plastic-palm hub s ......................2 t he r ear p anel of plastic-palm hub...
1 introduction thank you for choosing the plastic-palm 10base-t ethernet hub. The hub was designed and manufactured to give you years of trouble-free and reliable service. The hub is designed for plug-and-play installation and easy management. The hub provides an uplink connection for your network e...
2 the front panel of plastic-palm hubs 5-port ethernet hub 5-port ethernet hub with bnc port 8-port ethernet hub 9-port ethernet hub with bnc port.
3 17-port ethernet hub with bnc port the rear panel of plastic-palm hubs 5-port ethernet hub 5-port ethernet hub with bnc port 8-port ethernet hub.
4 9-port ethernet hub with bnc port 17-port ethernet hub with bnc port led indicators power (pwr): this indicator lights green when the hub is receiving power, otherwise, it is off. Collision (col): this indicator indicates data collisions on the respective ethernet segments of the hub. Whenever a c...
5 station to which the hub is connected is powered off, or if there is a problem with the link, the led will remain off. And the indicator blinking green when the data will be received to all other connected ports. Bnc: this indicator blinking green when the data is transmitted. Rear panel indicator...
6 power jack for the external power adapter..
7 installation installing the hub the site where you install the hub may greatly affect its performance. When installing, consider the following pointers: install the hub in a fairly cool and dry place, for the acceptable temperature and humidity operating ranges. Install the hub in a site free from...
8 cables and connectors cable characteristics: category 3 or better unshielded twisted-pair or eia/tia-568 compliant, 100-ohm shielded twisted-pair data cable with 0.4 to 0.6 mm (22 to 26 awg) wires in two or four twisted pairs (only two pairs--that is, four wires--are used for 10base-t ). Maximum s...
9 crossover cables when making an uplink connection between one hub and another (or between a hub and a switch or bridge) using x -type jacks at both ends, you must use a crossover cable. In a crossover cable, two pairs of wires are switched at one end. Carry out the following steps to create a cros...
10 specifications general standards: ieee 802.3 10base-t ethernet repeater, and ansi x3t9.5 twisted-pair transceiver topology: star protocol: csma/cd network data transfer rate: ethernet: 10mbps number of ports : 4 x stp + 1 x bnc, 5 x stp, 8 x stp, 8 x stp + 1 x bnc, 16 x stp + 1 x bnc network medi...
