Palm power To Go Handbook - page 10
Detaching Power To Go from your handheld
6
4.
Release the buttons.
5.
Follow the instructions for your handheld to determine when it is fully charged.
If your handheld has an LED that indicates charging status, it will light.
NOTE
For handhelds with an LED that indicates charging status, promptly
remove the recharging pack from your handheld after the handheld is fully
charged. If the recharging pack is not removed, the handheld’s LED will remain
lit, slowly draining the handheld’s batteries.
You may continue to use your handheld while it is being recharged. This may
cause the recharging process to take longer than it would if the handheld was not
being used at the same time.
Detaching Power To Go from your handheld
To detach your recharging pack from your handheld:
1.
Hold down the buttons on the sides of the recharging pack.
2.
Tilt the handheld forward and lift it up.