Operating manual & parts list 81091a 6 x 9 ″ belt & disc sander read carefully and follow all safety rules and operating instructions before first use of this product. 25899.09-1130
2 palmgren operating manual & parts list 81091aa description palmgren 6” belt and 9” disc sander is constructed of rugged die cast aluminum and cast iron providing stability and vibration-free operation. The 6 x 48” belt and 9” diameter disc are used to sand, deburr, bevel and grind large workpieces...
3 safety rules (continued) • keep children out of the workplace. Make workshop childproof. Use padlocks, master switches or remove switch keys to pre- vent any unauthorized use of power tools. Tool should be maintained • always unplug tool prior to inspection. • consult manual for specific maintaini...
4 installation (continued) running the unit on voltages which are not within the range may cause overheating and motor burnout. Heavy loads require that voltage at motor terminals be no less than the voltage specified on nameplate. Power supply to the motor is controlled by a single pole locking roc...
5 operation refer to figure 7 and 8. Warning: operation of any power tool can result in foreign objects being thrown into eyes which can result in severe eye damage. Always wear safety goggles complying with united states ansi z87.1 (shown on package) before commencing power tool operation. Caution:...
6 palmgren operating manual & parts list 81091a operation (continued) finishing long pieces: remove work stop. Apply only enough pressure to allow abrasive belt to remove material. • finishing curved edges: finish outside curves on flat portion of abrasive belt. Finish inside curves on idler drum po...
7 symptom motor will not start motor will not start; fuses blown or circuit breakers tripped motor fails to develop full power (power output of motor decreases rapidly with decrease in voltage at motor terminals) motor overheats motor stalls (resulting in blown fuses or tripped circuit breakers) mac...
8 palmgren operating manual & parts list 81091a figure 8 – replacement parts illustration for sander 12 17 17 17 18 18 16 10 70 8 8 9 11 6 34 33 32 33 33 33 44 30 31 31 31 31 28 25 69 4 29 29 29 29 5 23 57 27 26 3 3 15 20 2 2 2 2 22 5 4 53 58 2 28 56 43 40 40 37 41 38 42 49 45 21 51 50 35 55 62 64 6...
9 ref. No. Description part no. Qty. 1 abrasive belt 20768.00 1 2 8-1.25 x 10mm set screw * 10 3 collar 08403.00 2 4 rubber bushing 08402.00 2 5 6 x 1.0mm fiber hex nut * 1 6 idler drum shaft 24593.00 1 7 3ami-12 retaining ring 00519.00 2 8 bearing 6201zz 00520.00 2 9 idler drum 24450.00 1 10 thumb ...
Palmgren operating manual & parts list 81091a 10 notes.
Palmgren operating manual & parts list 81091a 11 notes.
Palmgren operating manual & parts list 81091a two year limited warranty palmgren warrants to the original purchaser that all products covered under this warranty are free from defects in material and workmanship for a period of two years from the date of the original purchase. We will repair or repl...
