Paloform Bento 32 Corten Owners And Installation Manual - page 4

4

BENTO 42 E | Owner and Installation Manual

CAUTION: 

HEAVY: Use care 

when lifting and 

placing to avoid 

injury and damage 

to property and the 

fire pit itself. Fire pits 

will require 2 or more 

people to lift.

PLACEMENT AND ASSEMBLY

1.  Please refer to ‘Clearances to Combustibles’ guide on page 6 of this guide for placement. 

2.  Ensure that the final location for the fire pit is as flat and level as possible. Also provide adequate drainage 

beneath the opening in the base of the fire pit body. 

3.  Completely unpack the fire pit.

4.  Remove Burner Assembly (1) from fire pit body and carefully set aside.

5.  Carefully lift the fire pit and place it in its final position. If there is a gas riser, fire pit vessel should be placed 

so that the stub is enclosed within the fire pit body (3).

6.  If the fire pit does not sit level, shim appropriately so that it is level and evenly supported.

7.  Connect to Natural Gas or Propane Source as per page 8 of this manual.

8.  Assemble Burner as per instructions on page 7.

9.  Check for leaks and test burner (see page 8).

10. Place Burner Assembly in Body.

11. Cover with Decorative Topping media as per instructions on page 7.

ATTENTION: Fragile! Concrete may chip or scratch if collided with other hard 

materials such as stone, metal, or other concrete. HANDLE WITH CARE!