Paloform caldera CIF-E-18 Installation Manual - page 7
7
CALDERA E CORTEN FIRE PIT | Owner and Installation Manual
TO ASSEMBLE THE BURNER
1. Connect the Burner Assembly to the gas/propane supply
using the supplied flex connector and following the
instructions on page 8.
2. Carefully leak test all connections following the procedure
on page 8.
3. Cover the burner pan evenly with burner media (lava
pebbles OR glass) so that the burner ring is covered with
a 1/2”-3/4” of media. Do not obstruct lighting port with
burner media!
4. Follow the Initial Lighting Instructions on page 10.
Make sure that the flame carries to all parts of the
burner. Turn OFF the appliance and let it cool before
proceeding to the next step.
5. Place decorative topping (if applicable), leaving the pilot
cover exposed. Placement of toppings will affect the
aesthetic character of the flame. Adjust positioning
if necessary. Always completely extinguish burner
and pilot and wait for media to cool before making
adjustments.
6. Do not cover pilot shield. Keep the lighting port open
and free of media. Do not use any media not supplied
by the manufacturer!
WARNING:
Failure to position parts in
accordance with these diagrams
and instructions and/or failure to
use parts specifically approved
for use with this appliance may
result in property damage or
personal injury.
CAUTION:
Do not remove the metal data
plates attached to the Outdoor
Fire Pit Burner. These plates
contain important information.
NOTICE:
Installation and repair should
be done by a qualified service
person. The appliance should
be inspected before use and at
least once annually by a qualified
service person. More frequent
cleaning may be required as
necessary. It is imperative that
control compartment, burner and
circulating air passageways of
the appliance be kept clean.
BURNER ASSEMBLY
LIGHTING PORT
GLASS MEDIA (NG ONLY)
LAVA MEDIA (LP & NG)
“RIVER ROCK” TOPPING