Paloform ROB-36 Installation Manual - page 8
8
Robata Outdoor Burner Owner and Installation Manual
OPERATING INSTRUCTIONS
1. STOP! Read the safety information on pages 1, 2 and 7 of this
manual.
2. Turn off all electric power to the appliance.
3. Do not attempt to light the pilot manually.
4. Turn the manual gas control valve to the OFF position.
5. Wait five (5) minutes to clear out any residual gas, then check for the smell
of gas at and around the appliance, including near the floor.
If you smell
gas, STOP! Follow the instructions on page 1 of this manual. If you do
not smell gas, continue to the next step.
6. Turn the manual gas control valve to the ON position.
7. Plug the supplied 7V DC adapter into a 110V power outlet.
8. Connect the wire to the DC input plug at the unit.
9. Replace the Heat Shield and Top Tray.
10. Turn on electric power to the appliance.
11. To turn off appliance, turn off electric power to the appliance.
TURNING OFF THE GAS TO THE APPLIANCE
1. Turn off all electric power supplied to the appliance if service is to be
performed. Unplug the 7V DC adapter from the power outlet.
2. If necessary, remove the Top Tray from the appliance to access the manual
shutoff valve on the gas line.
3. Turn the manual shutoff valve to the full OFF position.
LIGHTING YOUR FIRE PIT
WARNING:
This appliance is designed to be connected to a power
source that is controllable by a switch.
Do not connect 7V DC adapter to a live power source.