Page 1 of 20 majestic outdoor gas fireplace customer installation and operating instructions thank you for purchasing a majestic outdoor gas fireplace 1. To operate and maintain this appliance safely and correctly, please read these instructions thoroughly. 2. This appliance must be installed in acc...
Page 2 of 20 contents for your safety general information installation instructions general information fireplace dimensions clearance to combustibles mantels mantel chart hearth framing and finishing final finishing gas specifications gas inlet and burner pressures high elevations valve access gas ...
Page 3 of 20 for your safety do not operate this appliance before reading this instruction book. Warning: improper installation, adjustment, alteration, service or maintenance can cause injury or property damage. For assistance or additional information consult with rheem australia, your qualified i...
Page 4 of 20 for safe installation and operation of your gas appliance please note the following: a) this appliance gives off high temperatures and should be located out of high traffic areas and away from outdoor furniture and blinds or curtains. B) children and adults should be alerted to the haza...
Page 5 of 20 general information the gas log fires must be installed by a licensed gas fitter in accordance with requirements set out in as5601.1:2010 and any applicable building code regulations. The odgsr series are radiant gas log fires and are designed for outdoor installation only and must be l...
Page 6 of 20 see examples below of outdoor areas: figure 1: overall and framing dimensions..
Page 7 of 20 clearance to combustibles (refer figure 1) top framing ……………………………………………………0 mm to standoff spacer bottom……………………………………………………………0 mm side framing …………………………………………………..0 mm to standoff spacer back framing ………………………………………………….0 mm to standoff spacer perpendicular sidewall……………………………………..0...
Page 8 of 20 figure 2a figure 2b framing and finishing warning: check appliance to make sure it is levelled and properly positioned. The appliance should only be mounted on the following surfaces: a flat combustible (burnable) surface. A raised wooden platform. A concrete block or other solid object...
Page 9 of 20 figure 3 finishing caution: all joints between the finished wall and the appliance surround (top and sides) may be sealed only with a non-combustible material. Only non-combustible material can be applied as facing to the appliance surround as per figures 2a and 2b. Gas specification (a...
Page 10 of 20 valve access valve can be accessed in one of two ways: 1. Remove the front panel just below the front of the hearth pan. This is accomplished by lifting on the panel. To replace the valve access panel line up the two pins with the holes in the surround bottom and push the panel over th...
Page 11 of 20 log installation warning: as with all plastic bags, these bags are not toys and should always be kept away from children and infants. 1. Remove logs from packaging. 2. Place left rear log on rear support. Ensure that log is firmly positioned and there is no side to side movement. (refe...
Page 12 of 20 flame adjustment for units equipped with hi/lo valves, flame adjustment is achieved by rotating the hi/lo adjustment knob located near the centre of the gas control valve. Figure 12 – sit 820 gas control knob flame characteristics it is important to periodically perform a visual check ...
Page 13 of 20
Page 14 of 20 troubleshooting nova sit 820 standing pilot start check gas supply on gas supply on yes yes pilot stays lit yes pilot lights main burner yes system ok no no no no gas supply connected shut off valve open lockout has engaged. Wait 60 seconds and try again. Piezo not tight enough for goo...
Page 15 of 20 burner and burner compartment it is important to keep the burner and the burner compartment clean. At least once a year the logs should be removed and the burner compartment vacuumed and wiped out. Remove and replace the logs as per the instructions in this manual. Always handle the lo...
Page 16 of 20 parts list.
Page 17 of 20 outdoor fireplace models: odgsr36arn odgsr36arn 1. The raypak/paloma warranty - general a. This warranty is given by rheem australia pty ltd abn 21 098 823 511 of 1 alan street, rydalmere new south wales. B. Rheem offer a trained and qualified national service network who will repair o...
Page 18 of 20 g. This warranty only applies to the original and genuine raypak/paloma replacement parts. H. We reserve the right to transfer functional components from defective appliances if they are suitable. I. We reserve the right to have the installed product returned to the factory for inspect...
Page 19 of 20 what components are covered the period in which the fault must be appear in order to be covered what coverage you receive stainless steel firebox, grate and mesh screen (if the outdoor gas fireplace is not installed in a single-family domestic dwelling) year 3 repair and/or replacement...
Page 20 of 20 rheem australia has a service and spare parts network in all states. Our service network personnel are fully equipped to give the best service on your raypak/paloma gas heater. If your heater requires a repair or service please contact rheem service on 131 031. Repairs and service can ...
