Palsonic corporation pty ltd 1 joynton avenue waterloo nsw 2017 australia tel:(02)9313 7111 fax:(02)9313 7555 www.Palsonic.Com.Au palsonic customer service telephone australia:1300 657 888 34cm cordless remote colour television model: 3498 owner's manual type tested electrical safety as/nzs 3250 lic...
. This equipment has been designed and manufactured to meet the highest international standards, but, like any electrical apparatus which is operated at mains voltage, care must be taken if you are to obtain the best results and safety is to be assured. This is particularly important with audio and ...
Inside the preset door stand by channel selector previous call picture/time mute channel selector volume control time picture sleep tv/av timer 2 preset door power switch speaker remote sensor led indicator audio in video in antenna - vol + - ch + skip - mt + preset auto.
Installing batteries: 1. Remove the battery cover of remote control unit. 2. Insert two "aa" 1.5v batteries making sure the polarity (+ or -) of the batteries matches the polarity marks inside the unit. 3. Close the battery cover. * when the remote control unit is not used for a long time or the bat...
Use the channel selector button on the remote control unit to select channel 1) 0-9 channel 2) 10-19 channel 3) 20-29 channel 4) 30-39 channel 5) 40-49 channel 6) 50-59 channel 4 . 6 6 1- 2 1- 12 2- 8 2- 28 3- 5 3- 35 4- 8 4- 48 5- 9 5- 59.
5 1. Press the pset (preset on/off) button on the front panel. The current band and channel position will be displayed on screen (in green). 2. Press auto (auto preset) button, the appliance will search the signal of tv station in the order of vhfl, vhfh and uhf, as shown in the following, and memor...
6 skip button: function: when channel selector button is used to select channels, the channel will be skipped if they are set to "skip" mode. For example: set 2~7 channels to "skip" mode, the procedure of channel position increasing or decreasing. Operation: 1. Press pset (preset on/off) button to s...
Press stand by button, the appliance is set to stand by mode, the power indicator is lightened. Press stand by button again, the appliance is turned on and the indicator is turned off. 7 am 6 : 00 press the picture control button on the remote control unit. The function to be adjusted is selected in...
Sleep button (remote control unit) using sleep button allows you to have the appliance automatically turned off a predetermined time, and set the appliance to stand by mode. After the sleep function is set, the remaining time will be automatically displayed for 4 seconds every ten minutes. * if you ...
5. Press time button, the clock indicator is green instead of red on time function starts operating. Then press stand by button to set stand by mode. 6. The appliance will be turned on automatically when the clock reaches your setting time. * the on time operation will be cancelled if you switch off...
Trouble shooting guide many apparent malfunctions may be caused by slight misadjustment of regular controls or some other equally similar simple causes. If any problem arises in the operation of your set, first check through this list of symptoms and correction. Should the problem be unsettled, unpl...
Specifications: colour system scanning receivers channel cable channel if frequency inter carrier frequency power supply crt audio output antenna impedance dimension (mm) weight remote control unit power supply * design and specifications are subject to change without notice. : ccir pal b/g : 625 li...
Palsonic corporation pty ltd 1 joynton avenue waterloo nsw 2017 australia tel:(02)9313 7111 fax:(02)9313 7555 www.Palsonic.Com.Au palsonic customer service telephone australia: 1300 657 888 604-37823-10
