Panaccess P1000 User manual - page 5
5
Safety instructions
Read these instructions.
Heed all warnings.
Follow all instructions.
Do not use this apparatus near water.
The apparatus shall not be exposed to dripping or splashing and no objects
filled with liquids, such as vases, shall be placed on the apparatus.
Clean only with dry cloth.
Do not block any ventilation openings. Install it in accordance with the
manufacturer’s instructions.
Do not install near any heat sources such as radiators, heat registers, stoves,
or other apparatus (including amplifiers) that produce heat.
Only use attachments/accessories specified by the manufacturer.
Unplug this apparatus during lightning storms or when unused for long periods
of time.
To avoid electronic-shock hazards, do not open the cabinet, refer all servicing
to qualified service personnel. Servicing is required when the apparatus has
been damaged in any way, such as the power-supply cord or plug is
damaged, liquid has been spilled or objects have fallen into the apparatus, the
apparatus has been exposed to rain or moisture, does not operate normally,
or has been dropped.
The receiver requires careful handling to avoid potential damage. Be sure to follow
these requirements during transportation and installation.
During Transportation to the Subscriber Home
Transport the cable receiver in its shipping box or an equally padded container. Do
not expose the receiver to rain or moisture.
During Installation
Do not place the cable receiver in an enclosed area where the cooling vents are
blocked or the flow of air through the ventilation openings is impeded.
Install the receiver so that its position does not interfere with its proper ventilation.
For example, do not place the receiver on a bed, sofa, rug, or similar surface that
could block the ventilation openings.
Install the receiver away from heat sources such as radiators, heat registers and
stoves. Installation of the receiver near consumer electronics devices, such as stereo
receiver/amplifiers and televisions, is permitted as long as the air surrounding of the
receiver does not exceed 40°C (104° F).
Place the receiver on a flat surface and not prone to vibration or impact.