Panacom BL-1360HS User Manual - Turning On/off The Headset
Pg. 6
turning on/off the headset
Power on: Press and hold the MFB button for 2-3 seconds until the LED
flashes blue.
Power off: Press and hold the MFB button for 3-5 seconds until the red LED
stops flashing.
Pairing the headset with Bluetooth devices (phone or music device)
Ensure the headset is turned off, then press and hold the MFB button for 3-5
seconds until the LED flashes red and blue. Place the headset and Bluetooth
device (phone or music device) so that they are no further than 1 meter apart.
Activate the Bluetooth function on your Bluetooth device (phone or music
device). Please refer to the manufacturer’s instructions for instructions on
enabling Bluetooth on your device.
Once you have activated Bluetooth on your device, select the headphones “
BL-
1360hs” from the list of available Bluetooth devices.
If required, enter the password ‘0000’ to confirm & finalize pairing.
Once paired successfully, beep sound will be heard and the LED flashes
blue quickly for a few times while paired.
You can now start to use the headset.
Please note pairing mode on the headset will last for around 2.5 minutes. If no
devices are paired within around 2.5 minutes the headset will automatically
return to standby mode.
If pairing is unsuccessful, turn off the headphones first and then re-pair
following the above steps.
Once you have paired the headset with a device, the headset will remember this
device and will pair automatically when the device’s Bluetooth is activated and in
range. You do not need to re-pair any previously connected devices.
The headset will attempt to automatically connect to the last device it was