Panamax MIW-DUAL-SIGNAL-BAY Installation Instructions

STEP 1:

Select a location close to the equipment. In the case of a flat panel 

display, the recommended location is one that is behind the device 

and hidden from view once the Plasma TV is mounted. Cut a 4” 

wide by 3 3/4” high hole in the wall for the mounting bracket.

STEP 2:

Run the signal line(s) through the mounting bracket.

Install the mounting bracket in the hole.

STEP 3:

Remove the rubber plug from one of the Signal Bay Pass-

Throughs. Cut a hole in the rubber plug so that it fits snugly 

around the signal line. Pass the signal line through the Signal 

Bay Pass-Throughs, place the rubber plug over the signal line, 

and put the rubber plug back in place.

STEP 4:

Install the Max In-Wall Dual Signal Bay into the mounting bracket 

and secure with the included screws.

Signal Protection Module Usage:

Panamax In-Wall signal protection modules (sold separately), 

while not necessary for surge protection in the Max In-Wall Dual 

Signal Bay, may be used to provide a clean looking interface for 

the signal lines. When used in the proper manner the modules 

also provide total protection to the connected equipment.

NOTE:

In order for the signal protection modules to protect against surg-

es, the ground wire on the Max In-Wall Signal Bay may be con-

nected to the ground wire  on the Max In-Wall Power-PRO that is 

installed nearby (less than 1 foot away). Simply connect it with the 

same wire nut that is used to connect the Max In-Wall Power-PRO 

to the building wire.

1

PANAMAX MAX IN-WALL DUAL SIGNAL BAY INSTALLATION INSTRUCTIONS

INS00811  REV A  03/07

STEP 5:

Repeat steps 1-4 for the Dual Signal Bay located at the source 

components.