Panasonic AG-HPX370 Brochure & Specs - page 15
Remote Control-Ready
The AG-EC4G Extension Remote Control Unit or AJ-RC10G Remote
Control Unit* offer both studio use and direct connection to the
AG-HPX370 series. This lets you adjust the images and control the
camera operation while viewing the monitor.
*The AJ-RC10G can control only functions supported by the AG-HPX370 series. It cannot
control unsupported keys or dials.
HD/SD SDI Output Terminals and Down-Converter
The AG-HPX370 series comes with two output types: a composite video
output and two SDI outputs. In addition to HD-SDI output, the internal
down-converter allows high-quality SD video to be output. The aspect
mode is selectable.
• SDI OUT (HD/SD): Can also output signals with embedded audio.
When the AG-HPX370 series are set for HD-SDI output, backup
recording operation can be interlinked with the Rec Start/Stop controls
of an HD-SDI input-equipped Panasonic recorder, such as the
AG-HPG20. The AG-HPX370 series can also output down-converted
SD-SDI from an HD source.
• VIDEO OUT: Outputs SD (composite) signals. HD signals are down-
converted.
USB2.0 Interface
The AG-HPX370 series standard USB2.0 connector supports both Host
and Device modes. In Device mode, a P2 card slot can be used as an
external PC device, making it easy to upload data to a nonlinear editing
system or network server. In Host mode, an external hard disk drive can
be connected to the slot, making it easy to copy data from the P2 card,
write data to the card, or view thumbnails of stored video clips.
IEEE 1394 Interface
The IEEE 1394-compliant DVCPRO (6-pin) output connector lets you
input/output HD/SD compression streams including DVCPRO HD
without decoding.* This means you can connect and use a DVCPRO HD
VTR or P2 HD recorder for degradation-free backup recording.
* Output is not possible in 720p native mode (25pN), Interval-rec, and One-shot rec mode.
AVC-Intra is not supported. Text
memo, shot mark can not be added in Loop-rec, Interval-rec, or
One-shot rec mode.
TC IN, TC OUT, and GENLOCK IN Terminals
The AG-HPX370 series has a built-in SMPTE time code generator/reader.
TC IN and OUT terminals make time code throughput possible. The
GENLOCK IN terminal permits external time-code lock.
Other System Functions and Options
• UniSlot® wireless receiver compatible
(dual or single channel compatible channel)
* UniSlot® is a trademark of Ikegami Tsusinki Co., Ltd.
• XLR audio input: 2-channel mic/line inputs supporting 48V phantom
power supply.
• Multiple battery support, including Anton Bauer or IDX batteries*.
* The V-mount battery plate is required for IDX batteries.
• Equipped with earphone terminal (mini-jack) and speaker.
Rear terminal
Side terminal
IEEE 1394
DVCPRO HD
(AV Stream)
DVCPRO HD
Recorder
AG-HPX370 series
or
AG-HPG20
P2HD Portable
Recorder
HD-SDI
Analog Composite
AG-HPG20
P2HD Portable
Recorder
Monitor
AG-HPX370 series
SDI OUT
VIDEO OUT
USB 2.0
Upload
(DEVICE)
File Copy
(HOST)
HDD
AG-HPX370 series
NLE
10P Cable (10m/50m)
Camera Image
Remote Control
AG-HPX370 series
Monitor
VBS
AJ-RC10G
Remote Controller
or
AG-EC4G
Extension Control Unit
(ECU)