F568746 operating instructions air conditioner model no. Indoor unit outdoor unit cs-e7nkr cu-e7nkr cs-e9nkr cu-e9nkr cs-e12nkr cu-e12nkr cs-e15nkr cu-e15nkr cs-e18nkr cu-e18nkr cs-e21nkr cu-e21nkr cs-e24nkr cu-e24nkr cs-e28nkr cu-e28nkr quick guide quick guide before operating the unit, read these ...
2 english thank you for purchasing panasonic air conditioner table of contents table of contents operation condition safety precautions 4~5 remote control 6~8 indoor unit 9 troubleshooting 10 information 11 quick guide back cover note : the illustrations in this manual are for explanation purposes o...
3 table of contents operation condition operation condition use this air conditioner under the following temperature range temperature (°c) indoor *dbt *wbt cooling max. 32 23 min. 16 11 heating max. 30 - min. 16 - cu-e7nkr, cu-e9nkr, cu-e12nkr, cu-e15nkr, cu-e18nkr, cu-e21nkr, cu-e24nkr temperature...
4 safety precautions to prevent personal injury, injury to others, or property damage, please comply with the following. Incorrect operation due to failure to follow instructions below may cause harm or damage, the seriousness of which is classifi ed as below: warning warning this sign warns of deat...
5 warning warning power supply if the supply cord is damage, it must be replaced by the manufacturer, its service agent or similarly qualifi ed persons in order to avoid a hazard. It is strongly recommended to be installed with earth leakage circuit breaker (elcb) or residual current device (rcd) to...
6 remote control press the remote control’s button 1 to turn on or off the unit power • please be aware of the off indication on the remote control display to prevent the unit from starting/stopping improperly. 2 to set temperature • selection range: 16°c ~ 30°c (not applicable for fan mode). • oper...
7 6 to purify the air nanoe-g • removes/deactivates harmful micro-organisms such as viruses, bacteria, etc. • can be activated even when the unit is turned off. In this condition, fan speed and air swing cannot be adjusted. • nanoe-g starts automatically with the unit switched on with off/on . 7 to ...
8 remote control 11 press and hold for 5 seconds to dim or restore the unit’s indicator brightness. 12 press and hold for approximately 10 seconds to show temperature setting in °c or °f. 13 press to restore the remote control’s default setting. 14 not used in normal operations. On off set cancel ti...
9 indoor unit caution • switch off the power supply and unplug before cleaning. • do not touch the aluminium fi n, sharp parts may cause injury. Cleaning instructions cleaning instructions hint hint • do not use benzene, thinner or scouring powder. • use only soap ( ph7) or neutral household deterge...
10 troubleshooting the following symptoms do not indicate malfunction. The following symptoms do not indicate malfunction. Symptom symptom cause cause mist emerges from indoor unit. ► • condensation effect due to cooling process. Water fl owing sound during operation. ► • refrigerant fl ow inside th...
11 information for seasonal inspection after extended non-use • checking of remote control batteries. • no obstruction at air inlet and air outlet vents. • use auto off/on button to select cooling/heating operation. After 15 minutes of operation, it is normal to have the following temperature differ...
Quick guide remote control preparation remote control preparation 1 2 3 on off set cancel timer 1 2 3 set check clock reset ac rc 4 5 6 1 pull out 2 insert aaa or r03 batteries (can be used ~ 1 year) 3 close the cover 4 press clock 5 set time 6 confi rm mode mode fan dry auto heat cool select the de...
