Panasonic CS-MK120AKH Operating Instructions Manual - Timer Operation
10
AM
AM
l
l
l
l
l
l
l
l
l
AM
FILTER
POWER
TIMER
OFF/ON
Timer Operation
AM
Notes on OFF TIMER
•
When the OFF TIMER is set, the air conditioner automatically
adjusts the temperature setting (0.5°C up in COOL, 2.0°C down
in HEAT) to prevent excessive cooling for your pleasant sleep.
Timer functions are useful for automatically switching
the air conditioner on or off at night or in the morning.
You can also use OFF TIMER and ON TIMER in
combination.
1
Press
OFF-TIMER
while the air conditioner
is operating.
•
Check that the clock is correct.
If not, set the clock to the present time. (See page 7.)
Press
CANCEL
.
Then the TIMER lamp lights up.
■ To cancel the timer:
Press
OFF-TIMER
once again.
Then the TIMER lamp goes off.
OFF TIMER operation
Display
Press
until the time setting
reaches the point you like.
•
Every pressing of either button increases or decreases
the time setting by ten minutes. Holding down either
button changes the setting rapidly.
AM
l
l
l
l
l
l
l
l
l
l
Display
AM
is displayed.
blinks.
2
3
Press
ON-TIMER
while the air conditioner
is not operating.
Press
ON-TIMER
once again.
Press
until the time setting
reaches the point you like.
•
Every pressing of either button increases or decreases
the time setting by ten minutes. Holding down either
button changes the setting rapidly.
is displayed.
blinks.
Display
ON TIMER operation
1
2
3
Combining ON TIMER and OFF TIMER
•
A sample setting for combining the two timers is shown below.
Display
Present time: 11:00 PM
(The unit operating)
OFF TIMER at 0:00 a.m.
ON TIMER at 7:00 a.m.
Combined
(Example)
Notes on ON,OFF TIMER
•
When TIMER is set, the present time is not displayed.
•
Once you set ON,OFF TIMER, the time setting is kept in the
memory. (The memory is canceled when remote controller
batteries are replaced.)
•
When operating the unit via the ON/OFF Timer, the actual length
of operation may vary from the time entered by the
user.(Maximum approx. 10 minutes.)
➡
AM
AM
Display
Press
CANCEL
.
■ To cancel the timer:
Then the TIMER lamp goes off
.
■ In the following cases, set the timer again.
•
After a breaker has turned OFF.
•
After a power failure.
•
After replacing batteries in the remote controller.
ATTENTION
Then the TIMER lamp lights up.
•
Check that the clock is correct. If not, set the clock to the
present time (See page 7).