Panasonic CS-PC12MKF Operating Instructions Manual - page 13
ENGLISH
13
6 7
TO MONITOR HUMAN
PRESENCE & ACTIVITY
FOR ENERGY SAVING &
COMFORT
AUTO COMFORT
To optimize energy saving
AUTO
COMFORT
To maximize comfort
Heat Source & Movement
Normal
High
Low
Set Temperature
None
Set Fan Speed
≤ Medium
Fan
+1 tap*
+2°C
-1°C
+1 tap
+0.3°C
* For first 15 minutes or until set temperature is reached.
• Sensor may not detect moving objects further than 7m
away or beyond detection angle.
• Sensor sensitivity is infl uenced by indoor unit location,
movement speed, temperature range, etc.
• The sensor may mistakenly detects pets, sunlight, certain
lighting, fl uttering curtains and light refl ection as human
being.
8
Press and hold for 5 seconds to dim or restore the
unit’s indicator brightness.
9
Press and hold for approximately 10 seconds to
show temperature setting in °C or °F.
10
Press to restore the remote control’s default setting.
11
Not used in normal operations.
INFORMATION
FOR SEASONAL INSPECTION AFTER EXTENDED NON-USE
• Checking of remote control batteries.
• No obstruction at air inlet and air outlet vents.
• After 15 minutes of operation, it is normal to have the following
temperature difference between air inlet and air outlet vents:
Cooling: ≥ 8°C
FOR EXTENDED NON-USE
• Turn off the power supply and unplug.
• Remove the remote control batteries.
NON SERVICEABLE CRITERIAS
TURN OFF POWER SUPPLY AND UNPLUG
then please consult authorized dealer under the
following conditions:
• Abnormal noise during operation.
• Water/foreign particles have entered the remote
control.
• Water leaks from Indoor unit.
• Circuit breaker switches off frequently.
• Power cord becomes unnaturally warm.
• Switches or buttons are not functioning properly.
NOTES
NOTES
AUTO
COMFORT
,
• Can be activated in all modes and can be cancelled
by pressing the respective button again.
• Cannot be selected at the same time.
TO SET THE TIMER
TO SET THE TIMER
• To turn ON or OFF the unit at a preset time.
ON
OFF
1
2
SET
Select ON or
OFF timer
Set the time
Confi rm
• To cancel ON or OFF timer, press
ON
or
OFF
then
press
CANCEL
.
• When ON Timer is set, the unit may start earlier (up
to 15 minutes) before the actual set time in order to
achieve the desired temperature on time.
• Timer operation is based on the clock set in the
remote control and repeats daily once set. For clock
setting, please refer to Remote Control Preparation at
back cover.
• If timer is cancelled manually or due to power failure,
you can restore the previous setting (once power is
resumed) by pressing
SET
.
Information for Users on Collection and Disposal of Old Equipment and used Batteries
[Information on Disposal in other Countries
outside the European Union]
These symbols are only valid in the European
Union. If you wish to discard these items, please
contact your local authorities or dealer and ask for
the correct method of disposal.
Note for the battery symbol
(bottom two symbol examples):
This symbol might be used in combination
with a chemical symbol. In this case it
complies with the requirement set by the
Directive for the chemical involved.
Pb