Panasonic DMP-BDT500 Operating Instructions Manual - page 37
Referen
ce
37
VQT3W07
You have forgotten your ratings password.
You want to cancel the ratings level.
¾
The ratings level returns to the factory preset.
– “00 RET” is displayed on the unit’s display.
This unit does not recognize the USB
connection correctly.
¾
Disconnect and reconnect the USB cable. If it
still does not recognize the connection, turn
this unit off and on again.
¾
USB devices may not be recognized by this
unit when connected using the following:
– a USB hub
¾
If you connect USB HDD to this unit, use the
USB cable that is supplied with the HDD.
The buttons of the unit do not work.
¾
Touch the buttons with your finger. They may
not work if operated with your fingernails or
hands wearing gloves.
The images from this unit do not appear on
the television.
Picture is distorted.
¾
An incorrect resolution is selected in “HDMI
Video Format”. Reset the setting as follows:
– “00 RET” is displayed on the unit’s display.
Set the item again. (> 30)
¾
When “3D BD-Video Playback” in the Setup
menu is set to “Automatic”, images may not
be output depending on the connection
method. After removing the disc from this unit,
select “Set before play” in the Setup menu,
and select “2D Playback” in the setup screen
displayed when playing 3D discs. (> 32)
1 While the unit is on, press and hold [KEYS],
the yellow button and the blue button at the
same time for more than 5 seconds.
2 Press the red button repeatedly until “03 VL”
is displayed on the unit’s display.
3 Press the green button.
– a USB extension cable
Picture
1 While the unit is on, press and hold [KEYS],
the yellow button and the blue button at the
same time for more than 5 seconds.
2 Press the red button repeatedly until
“04 PRG” is displayed on the unit’s display.
3 Press and hold the green button for more
than 3 seconds.
– When Dolby Digital Plus, Dolby TrueHD,
and DTS-HD audio are not output in
bitstream, select “Yes” in “Default Settings”
and make proper settings. (> 35)
¾
The unit and television are using different
video systems.
1 While the unit is on, press and hold [KEYS],
the yellow button and the blue button at the
same time for more than 5 seconds.
– “00 RET” is displayed on the unit’s display.
2 Press the red button repeatedly until “05 P/N”
is displayed on the unit’s display.
3 Press and hold the green button for more
than 3 seconds.
The system switches from PAL to NTSC or
vice versa.
¾
The system used on the disc doesn’t match
your television.
– PAL discs cannot be correctly viewed on an
NTSC television.
– This unit can convert NTSC signals to
PAL60 for viewing on a PAL television
(> 31, “NTSC Contents Output”).
DMP-BDT500EB-VQT3W07.book 37 ページ 2012年2月24日 金曜日 午後4時17分