Panasonic DVCPRO AJ-CA901 Operating Instructions Manual - Contents
3
Safety precautions..................................................................... 2
Features .................................................................................... 3
Installation ................................................................................. 4
Parts and their functions............................................................ 5
Rear panel ..................................................................................................5
Left side ......................................................................................................6
Right side ....................................................................................................6
Connectors and signals ............................................................. 7
Selecting the intercom microphone ........................................... 8
Specifications ............................................................................ 9
Contents
The unit has the following features.
≥
It enables high picture quality transmission by means of non-compressed wide-band 360 Mbps serial component signals.
≥
It uses a tri-axial cable.
≥
It enables a DVCPRO camera recorder to be operated as a system camera.
≥
It enables the transmission of the signals of two audio channels.
≥
It enables RET 1CH and PROMPT 1CH transmission.
≥
Its TRIAX connector area can be rotated for easy operation.
≥
It comes with RET and PROMPT output connectors (BNC).
≥
It comes with a DC 12 V output jack.
Features
Thank you very much for purchasing this AJ-CA901 Camera Adapter (referred to throughout these instructions as “the unit”).
The unit is installed in a DVCPRO50 AJ-SDX900 camera recorder and used together with the AJ-BS901 base station to
configure a transmission system which uses a tri-axial cable to enable the camera recorder to be operated as a system
camera.
Use of non-compressed wide-band 360 Mbps serial component signals makes high picture quality transmission possible so
that the high picture quality of the images shot by the DVCPRO camera recorder are transmitted with their high picture quality
kept intact.
This serves to expand the range of the DVCPRO camera recorder’s operating formats.
Note:
≥
≥
When the unit is connected, external input signals cannot be recorded on tape inside the camera
recorder.“CAM” must be selected as the REC SIGNAL setting on the SYSTEM SETTING menu of the
camera recorder.
≥
≥
When using an external power supply (DC 12 V) for the unit, always turn the main power switch of
the base station (AJ-BS901) ON before turning the power switch of the camera recorder ON.