6 installation for fv-07vba1 (wall mounting) c g a.
Install the fan at least 1.5m (5 feet) above the floor. The motor/grille assembly fv-07vbb1 must be installed with housing can fv-07vba1 that is marked on the carton to indicate the suitability with this model. Other motor/grille assembly can not be substituted. G a.
(st4.2x20) 12 h h a a a a c b b m m m m m g a.
5 1. Affix the fan housing to joist with 3 long screws (st4.2x20) by affixing first 1 screw 2. Install the v duct and secure it entilation with a clamp and seal it with mastic or approved foil tape. A 4 inch circular duct is needed to connect to the relevant part of adaptor. (fig.2) fig.1 fig.2 fig....
6 installation for fv-07vba1 continued 10. Finish ceiling work. Ceiling hole should be aligned with the inside edge of the flange. (fig.5) fig.5 after finishing the ceiling job, fill gap between flange and ceiling with caulk or other sealant to prevent air leakage. 7 7/8 (200) 7 7 /8 ( 2 0 0 ) ceili...
7 2.Wash and clean grille assembly. (use non-abrasive kitchen detergent, wipe dry with clean cloth.)(fig.12) 3. Remove dust and dirt from fan body using a vacuum cleaner. (fig.13) 1. Remove grille assembly. (squeeze mounting springs and pull down carefully.)(fig.11) 4. Using a cloth dampened with ki...
The ducting from this fan to the outside of the building has a strong effect on the air flow, noise and energy use of the fan. Use the shortest, straightest duct routing possible for best performance, and avoid installing the fan with smaller ducts than recommended. Insulation around the ducts can r...
