Panasonic PV-DAC14 Operating Instructions Manual - Supplying Power
5
English
• If the temperature of the Battery is extremely
high or extremely low, the [CHARGE] Lamp
may continue flashing, and the Battery may
not be charged. After the temperature of the
Battery has decreased or increased sufficiently,
charging starts automatically. If the [CHARGE]
Lamp continues to flash even after the Battery
temperature has decreased or increased
sufficiently, the Battery or AC Adaptor may be
faulty. In this case, please contact a dealer.
• If the Battery is warm, charging takes a longer
time than normal.
• If you use the AC Adaptor near a radio, radio
reception may be disturbed. Keep the AC
Adaptor 3 feet (1 meter) or more away from a
radio.
• When using the AC Adaptor, it may generate
whirring sounds. However, this is normal.
• After use, be sure to pull out the AC Cable from
the AC Jack. (If they are left connected, a minute
amount of current is consumed.)
• Always keep the electrodes of the AC Adaptor
and Battery clean.
Supplying Power
1
Connect the AC cable to the AC adaptor
and the AC jack.
2
Connect the DC cable to the AC adaptor.
3
Connect the DC cable to this product.
• The output plug of the AC cable is not
completely connected to the AC adaptor jack.
As shown in
1
, there is a gap.
• Do not use the power cord for other equipment
since the power cord is exclusively designed for
the Camcorder. Or do not use the power cord of
other equipment for the Camcorder.
1
For Model PV-GS150
• When the DC Power Cable (supplied) is connected
to the AC Adaptor, the AC Adaptor cannot charge
the Battery.
DC Cable
(K2GJ2DZ00018)
(Supplied)
For Model PV-GS65/250/400
(PV-GS150 shown)
(PV-GS400 shown)
1
DC Cable
(K2GJ2DZ00017)
(Supplied)
1
For Model PV-GS250/400 :
Lift up the Viewfi nder beforehand.
2
Connect the AC cable to the AC adaptor
and the AC jack.
3
Connect the DC cable to the AC adaptor.
4
Connect the DC cable to this product.
• The output plug of the AC cable is not
completely connected to the AC adaptor jack.
As shown in
1
, there is a gap.
About the AC Adaptor
• Do not use the power cord for other equipment
since the power cord is exclusively designed for
the Camcorder. Or do not use the power cord of
other equipment for the Camcorder.
• When the DC Power Cable (supplied) is connected
to the AC Adaptor, the AC Adaptor cannot charge
the Battery.