Playseats GEARSHIFT HOLDER - SEAT VERSION Manual - page 4
GEARSHIFT HOLDER - SEAT VERSION • MANUAL
Safety instruction: the gearshift holder is an accessory for the Playseat Evolution;
developed to allow the gearshift of the steering wheel of the Logitech G25 to be fastened
to the Playseat Evolution. It can therefore be used only for this purpose.
We would also like to point out that the gearshift can be assembled for both left-hand and
right-hand use:
- if you wish to assemble the gearshift for right-hand use, then use only component A;
- if you wish to assemble the gearshift for left-hand use, then use only component B.
This manual has assumed assembly for right-hand use. If you wish to assemble the gearshift for left-
hand use, then simply follow the instructions, except for the fact that you should assemble it on the
other edge of the chair and use component B instead of A.
1. Using the internal wrenching bolts (X & Y), assemble the fastening plate (A) on the inner edge
of the chair frame (photos 1 & 2). First of all, completely unscrew the bolts and then slide
component A between the square cross tube and the side plate of the chair frame.
Then screw the bolts back in and tighten them fully.
2. Then screw in the setscrews (D) a few turns in the fastening plate A and the T-piece C.
Then slide the T-piece (C), with the setscrew facing downward, into the fastening plate (A)
and tighten the setscrew (photo 3).
3. Now slide the holder (E ) into the T-piece (C) and tighten the setscrew in the T-piece (photo 4).
The gearshift holder is now ready to assemble the gearshift of the Logitech G25 steering wheel.
Playseats wishes you the ultimate racing experience in your own home!