PlexiDor Electronic Pet door Owner's Manual - C O D E
To Change the Open/Close Time on Pet Door -
1. Remove the motor cover on the pet door by squeez-
ing the cover on both sides and tipping the motor cover
down and out.
2. Remove the panel cover screw on the pet door. This
screw is located just below and to the left of the metal
spring. See diagram #5. When you remove the panel
cover screw, hold the panel in place with your hand or it
will drop straight down. Slide the panel cover down,
exposing the green electronic controls board. Locate the
Close Time and Open Time dip switches on the green
board. See Diagram #8A below.
3. To change Open Times: Flip the dip switches to
match the settings shown in Diagram #8B for the differ-
ent open times. The dip switches are white.
Diagram #8B
Diagram #8A
Plexidor
®
Electronic Owners Manual Pg 9
Version 20091112
White Switch Positions
for Panel Close Time
Time allowed to close
before sounding alarm
10 Seconds
20 Seconds
30 Seconds
45 Seconds
Senses for obstruction.
Pauses for 5 seconds if
obstructed, then tries
continuously to close.
No alarm.
Factory
Setting
4. To change Close Times: Flip the dip switches to
match the settings shown in Diagram #8C for the dif-
ferent open times. The dip switches are white.
Open/Close Time Adjustments on Pet Door:
Diagram #8C
White Switch Positions
for Panel Open Time
Time allowed before door
starts to close
1 Second
3 Seconds
5 Seconds
7 Seconds
Factory Setting
9 Seconds
11 Seconds
13 Seconds
15 Seconds
C O D E
1 2 3 4 5 6 7 8 9 0 1 2
1 2 3
4 5 6
7
8 9 10 11 12
1
2 3 4
5 6
1 2 3 1 2 3
CLOSE TIME
OPEN TIME
PET DOORS USA
* See inside of motor cover for quick instructions on
set-up, collar key programming and changing open
and close time.