Summary of JARRAH
Page 1
P h o n o p r e a m p l i f i e r.
Page 2
2.
Page 3
3 congratulations congratulations congratulations congratulations on your decision to become the proud owner of this plinius jarrah phono preamplifier. This manual has been prepared to help you understand the operation of your amplifier, and to provide information about its design and the variety of...
Page 4
4 introduction ...................................................................................................................................Page 3 precautions ...................................................................................................................................Page...
Page 5
5 please take special note of the following precautions before operating your new preamplifier: • this preamplifier operates at hazardous voltage levels. We recommend that any work requiring removal of the lid be referred to a suitably qualified and experienced service technician. • do not attempt t...
Page 6
6 placement and ventilation ventilation through and around your plinius jarrah phono preamplifier should be kept unimpeded, so ensure that the heat vents (slots in the lid) are not covered or restricted in any way. Also refrain from placing the plinius jarrah on top of other electronic equipment to ...
Page 7
7 it is important that you connect your preamplifier (outputs) and phono turntable (inputs) to your plinius jarrah phono preamplifier correctly to ensure the preamplifier is not damaged, and sounds its best within your system. Connect your phono turntable to the inputs on the back of the plinius jar...
Page 8
8 to achieve a sound performance that is correctly aligned to your room, make sure all of the leads carrying signals for the right channel loudspeaker are connected to the right input/outputs on your power amplifier/preamplifier/cd player etc. Signals for the left channel should be wired in a simila...
Page 9
9 phono cartridge loading adjustment the phono cartridge load can be adjusted to suit your particular phono cartridge, using two pairs of internal blue mini-switches. The jarrah mini-switches are factory set to a 47kΩ load. Also, switch 1 is set in the on position. This is a 220pf capacitive setting...
Page 10
10 phono gain adjustment the phono stage can also be set to high or low gain to suit your phono turntable specifications (high gain is the factory setting). Disconnect the lead from the iec socket on your plinius jarrah. Carefully remove the lid by undoing the six cap screws. Locate the small black ...
Page 11
11 s ffff requency requency requency requency rrrr esponse esponse esponse esponse :::: phono riaa network 20hz to 20khz ±0.2db. S dddd istortion istortion istortion istortion : typically s hhhh um um um um & n & n & n & n oise oise oise oise :::: -70db, a weighted (input loaded). S iiii nput nput n...
Page 12
12 date of manufacture .......................................................................................................................Page 3 iec power connector...............................................................................................................Pages 8,10 input term...
Page 13
13 all operational, technical and descriptive material published here is subject to change at any time without notice. For further product information or queries, please contact us at the address below. Plinius plinius plinius plinius products are designed and manufactured by: audible technologies l...