Plinius SA-50 Instruction Manual - page 3
Plinius SA-50 instruction manual. Page 3
WARNING
The SA-50 power amplifier can be operated in bridged mode and may deliver in excess of
200 Watts into 8 Ohms. This amplifier is also capable of a very large peak current
delivery.
This SA-50 power amplifier operates in Class A and is therefore capable of generating a
moderately high temperature which requires careful placing to avoid any effect this heat
may have on other equipment, furniture and fittings etc.
DO NOT remove the top cover from this amplifier. Hazardous voltages are present.
Any repair work should be referred to a suitable qualified and experienced service person.
DO NOT attempt to connect any input of this amplifier to any of its outputs.
DO NOT earth any output terminal or connect any of these terminals together without
following the instructions in this manual or seeking qualified assistance.
DO NOT place this amplifier in any position where liquids or any foreign
material may accidentally enter it.
DO NOT connect any voltage source, short circuit, earth / ground or appliance ( other
than suitable HiFi quality loudspeakers ) to any output terminal.
Some preamplifiers, processors, CD players etc, produce large switching pulses when
switched on, causing a loud click through the loudspeakers. For this reason, turn on all
other equipment in your system and operate the
MUTE circuit of the amplifier before turning on the SA-50.
NOTE: Plinius preamplifiers do not cause this problem.
Plinius SA-50 instruction manual. Page 4