PNI B2500 User Manual - page 10
Method two:
Press the power button on the camera backside, then can see the camera power led to flicker, it
means can pair up with the monitor.
Use pin to press pair key on the Monitor backside (see above icon), the pairing is successful when
the power led of camera stops to flicker.
NOTE : If want to pair more cameras with the monitor, so please select next channel by right
navigation button on the monitor to pair with another camera, so you can see next
channel(CH2 or CH3 or CH4) on the top of the Monitor ,the pairing method same as above
process.
Signal Indicators:
Signal Strength
Indicators
Description
Perfect signal
Low signal
No signal
Note:
when you take care of your baby sleeping by our baby monitor kit, you
should note the signal strength indicators on the LCD monitor. Please see above
table.
Troubleshooting
Problem
Solution
No video
Check the DC power of camera or batteries of the
camera if works well.
Make sure the camera and monitor in effective
range.
When the camera works by battery and
then change to works by DC, when
insert DC to DC port on camera, but the
camera does not work and power off .
Please press power button on the camera backside
to turn on it.
When camera works by battery and then insert DC
to DC port , the camera stops to work, so turn off
the battery working due to protect the batteries
which are in the camera , you know the batteries in
the camera can not charge by DC.
Two ways talk --- low volume
Adjust the volume by UP/DOWN key on monitor or