Pocket Radar PR1000 User Manual And Manual - page 5
POCKET RADAR™
Making Speed Measurements (Con’t)
4
Memory
Press and release the black RECALL button to display the memory. Each time you press the
RECALL button, the Pocket Radar™ will display a previous speed reading, beginning with
the most recent speed reading, up to the last 10 readings. When you reach the end of the
memory the display will present “ - “. If you continue to press the button beyond the end of
the list, it will start over and again present the most recent speed. If the display turns off (goes
blank) before you view all of the previous readings, it will start over from the beginning of the
list and present the most recent speed when you press RECALL again.
Power Off
There is no need to turn the Pocket Radar™ off. The Pocket Radar™ contains an automatic
battery saving shut-off feature. After 30 seconds with no button pushes, the unit will
automatically power off. This helps to increase battery life to over 10,000 measurements using
Alkaline AAA batteries. The battery life indicator icon shows up on the lower left hand corner
of the display. It will indicate the amount of battery life available and warn you when you
need to change the batteries. The battery life indicator will blink when battery life drops to a
very low level. Please remove the batteries for long-term storage.
Changing Units of Measurement
The Pocket Radar™ displays speed in units such as miles per hour (MPH) or kilometers per
hour (KPH). To change the units of measurement, press and hold the RECALL button. While
holding the RECALL button down, press and release the RED button and then release the
RECALL button. The currently selected units indicator will blink. To advance to the next units
selection, press and release the RED button. Continuing to press the RED button will cycle the
units of measurement again. When the desired units of measurement show up on the display,
press the RECALL button to return to normal operation with the new units setting.