Pocket UK NR201HPUK User Manual - -11-

Manual is about: HEADSETPHONE

Page of 14

Download

Print this page

Bookmark us

-11-

12.10 BASE UNIT LATCHABLE MUTE

Pressing the MUTE button during a call will deactivate speech transmission. When

mute is activated, its LED indicator will light up. Press the mute button again to

deactivate the mute function.

12.11 SAVE FUNCTION

The SAVE button is used to store a dialled number, it may store up to 32 digits. To

store a number press SAVE after the number had been dialled.

13.

OPERATING PROCEDURE FOR PBX CONNECTION

The Executive NR201HPUK Headsetphone is suitable for connection to a PABX

which returns secondary proceed indication.

13.1 PBX RECALL

When connected to a PBX, the telephone will send a Recall Signal to the exchange

when the RECALL button is pressed. This NR201HPUK Headsetphone provides

either TIMED LINE BREAK RECALL or EARTH RECALL. Consult your PBX supplier or

maintainer to ascertain which is compatible with your PBX. Having established which

you require select either ELR (Earth Recall) or TBR (Timed Line Break Recall) using

the ELR/TBR switch.

NB. Like the mute key the Recall key is a ‘hard switches’ not a ‘soft press’ key.

This means that it will only depress slightly, and will remain depressed until

released.

13.2 PABX PAUSE FACILITY

On PABX systems which provide secondary proceed indication you must wait for the

secondary proceed dial tone after dialling the initial access digit(s), normally 9 for an

outside line. For correct operation of the Memory facilities it is therefore necessary to

store a Pause after the access digit to ensure correct dialling. Pressing the LNR key

automatically inserts a 3.6 second pause in the dialling sequence.

NB: Do not enter more than 3 consecutive pauses. Failure to comply with this may

result in unsatisfactory operation and will invalidate the approval.

13.3 MESSAGE WAITING OPERATION

On 4 wire systems set the switch to 2/5 to enable message waiting on compatible

systems. For 6 wire systems set the switches to 1/6. Only one message waiting

telephone may be connected to an extension. If more than one message waiting

telephone is connected to a line, the system may interpret this as an off hook

condition.

NR201HPUK User Guide 24/6/03 5:18 pm Page 13

« ‹ Prev 8 9 10 11 12 13 14 Next › »

Summary of NR201HPUK

Page 1
User guide international headsetphone nr201hpuk executive nr201hpuk user guide 24/6/03 5:18 pm page 1.
Page 2: -1-
-1- contents 1. Guarantee 2 2. Conditions of use 2 3. Facilities and features 2 4. Locations of controls 3 5. Utilisation of controls 4 6. Installation 4 7. Setting the dialling mode and recall mode 5 7.1. The dial mode selector switch 5 7.2 the recall mode selector switch 5 7 3 network services 6 8...
Page 3: -2-
-2- 1. Guarantee your executive nr201hpuk headsetphone is guaranteed from the date of purchase. If found to be faulty within the guarantee period it will be repaired or replaced at our discretion, subject to our standard terms and conditions. The guarantee does not cover accidental damage or neglige...
Page 4: -3-
-3- 4. Locations of controls recall save mute with indicator mode store save shift tone set time view lnr/pause headset with indicator set tone headset tbr recall dialling tone elr pulse wall mount off-hook handset reset hook switch wall mount mute button in handset lcd display ring / mw indicator s...
Page 5: -4-
5. Utilisation of control the button functions are as follows: 0 - 9 - dialling digits ✽ - # - dialling codes for mf signalling recall - for use on a pbx or for star services save - used to store the last number redial into a memory tone - switches from loop disconnect to dtmf during dialling redial...
Page 6: -5-
-5- 7. Setting the dialling and recall mode the settings must be carried out before connecting the telephone to the telephone socket. Please note that batteries are not supplied with the unit. Two preset switches will be found situated underneath the memory card inlay. These are the dial mode select...
Page 7: -6-
-6- 7.3 network services bt are replacing all local exchanges with new digital systems. They will give improved clarity and reliability. If you are on a digital exchange, you can instruct it to ring you back with the cost of your call. Or you can use it to set up reminder calls, where the exchange r...
Page 8: -7-
-7- 8. Connecting to telephone socket when the setting up instructions have been completed, connect the plug at the end of the telephone lead into the telephone socket. The plug will only fit the correct way round. 9. Setting the clock 1. Lift the handset or press the headset button. 2. Enter the cl...
Page 9: -8-
-8- 12. Operating procedures two modes of operation are provided; normal handset mode where the handset is lifted and replaced in the normal manner and headset mode where the caller or called party is heard through the headset. When making or receiving a telephone call, you can alternate between the...
Page 10: -9-
12.3 headset operation headset button using the headset button, you can make calls via the headset without having to move the handset to do so. By pressing the headset button you can obtain a line, answer an incoming call or disconnect the current call. Important calls can be transferred from the ha...
Page 11: -10-
12.4 mixed mode operation if you are connected to an exchange requiring pulse dialling and you wish to route your calls via an alternative carrier (if available), it is necessary to dial an access code in pulse mode followed by pressing * button and then an authorisation code in tone mode. 12.5 reca...
Page 12: -11-
-11- 12.10 base unit latchable mute pressing the mute button during a call will deactivate speech transmission. When mute is activated, its led indicator will light up. Press the mute button again to deactivate the mute function. 12.11 save function the save button is used to store a dialled number,...
Page 13: -12-
-12- 13.4 general use it must be noted that there is no guarantee of correct working of this telephone in all circumstances when connected to a pbx. Any difficulties should be referred to the telephone supplier. This telephone is approved for connection to most pbx’s. The supplier of this telephone ...
Page 14
All pocket uk international telephones are manufactured to comply with ce standards distributed by: pocket (uk) international ltd incom house waterside trafford park manchester m17 1wd tel: (0161) 935 1000 fax: (0161) 935 1001 email: sales@pocketuk.Com © pocket (uk) international ltd. 2003 nr201hpuk...