1. Description controls and indicators ①. Power switch: on/off switch. ②. Output terminal: positive polarity (+) is red, negative polarity (-) is black, earth and chassis ground is green. ③. Digital volt meter: indicates the output voltage. ④. Digital current meter: indicates the output current. ⑤. ...
2. Specification model 3003 3005 3006 3015 3032 3033 output dc voltage output dc current 0-30v 0-3a 0-30v 0-5a 0-60v 0-1.5a 0-30v 0-1.5a dual 0-30v 0 - 3a dual 0 - 30v 0 - 1.5a dual 5v, 5a fixed load regulation (load effect) ≤ 0.02% + 2mv ≤ 0.05% + 5ma line regulation (source effect) ≤ 0.02% + 2mv ≤...
3. Operation warning: before connecting line power to your power supply, make sure that the ac input voltage is correct for your power source. Turn-on checkout procedure. A) turn a-adj control fully counter clockwise. B) set ac power switch push to on position, digital display and cv lamp should lig...
Constant current operation to set up a power supply for a constant current operation, proceed as follows: a) turn a-adj control fully counter clockwise to ensure that output decreases to 0 a, and then on power supply. B) adjust v-adj control (no load connected) for maximum output voltage allowable(v...
4. Maintenance warning: the following instructions are for use by qualified personnel only. To avoid electrical shock, do not perform any servicing other then contained in the operating instructions unless you are qualified to do so. Fuse replacement if the ac fuse blows, the cv or cc lamp will not ...
5. Calibration adjustment adjustment of the rating voltage. A) connect digital multimeter across output terminals of supply and set the dc volt position. B) turn on supply and push on dc out push button switch. C) adjust voltage controls (coarse, fine) fully clockwise. D) adjust s203 for a reading o...
