ProtekRC Prodigy 620 DUO Instruction Manual - page 15
· 14
INITIAL PARAMETER SETUP (USERS SETUP)
When using the optional temperature probe to monitor the
battery, the temperature cut-off can be turned on or off. When
turned on, the maximum temperature of the battery can be set. If
the battery reaches this temperature the charge process will be
terminated automatically.
A battery pack may become hot when cycled through multiple
charge and discharge cycles. When cycling a battery pack, this
value will insert a delay (1-60 minutes) between charge and
discharge processes to allow time for the pack to cool.
Trickle charge mode for NiCD and NiMH batteries can be turned
on or off. When turned on, the charger will supply the desired
charge current to achieve a full charge without overheating the
battery after it has been fast charged.
The Prodigy 620 DUO has an additional safety timer that begins
when a charge process is started; the safety timer can be set to
prevent overcharging in case of a faulty battery or incorrect
charger settings. The value of the safety timer should be set high
enough to allow sufficient time for the charge process to finish.
The capacity cut-off function regulates the maximum capacity that
will be supplied during the charge process. Should the Delta-peak
sensitivity not terminate the charge process, nor the safety timer,
the capacity cut-off will stop the charge at the selected capacity
value.
Both the beep that sounds when a button has been pressed and
the beeping during operating that indicate different mode
changes can be turned on or off.
When an automobile battery for power input, you may set a low
input voltage cut-off to protect the battery from damage. If the
input voltage drops below the specified value the charge process
will be terminated.
The brightness of the LCD screen can be adjusted.
DEC INC
DEC INC
INC
DEC
D
EC INC
D
EC INC
D
EC INC
INC
D
EC
D
EC INC
INC
D
EC
INC
D
EC
D
EC INC
D
EC INC
D
EC INC
D
EC INC
D
EC INC
INC
D
EC
D
EC INC
INC
D
EC