Protemp PT-02-230 User's Manual And Operating Instructions - page 2
Page 2
EN
Electric Fan Heater User’s Manual
Introduction
Electric Fan Heater
NEVER LEAVE HEATER
UNATTENDED WHILE BURN-
ING, OR WHILE CONNECTED
TO A POWER SOURCE.
-
At first turn the thermostat to “Max” and let the
heater operate with full power input. When the
room temperature reaches the required value, turn
the thermostat to the left until it switches off.
-
The thermostat will then switch on and off auto-
matically to control the room temperature
according to the preset value and to keep the
room temperature constant.
-
When using the heater for the first time, you may
notice a slight emission of smoke. This is quite
normal and it stops after a short time. The heating
element is made of steel and was coated with a
layer of protective oil during production. The
smoke is caused by the leftover oil as it is heated.
Technical Specifications
Specifications subject to change without notice
Thermostat Instructions
-
The fan heater is not suitable for use outdoors in
damp weather, in bathrooms or in other wet or
damp environments.
-
Please note that the fan heater can become very
hot and should, therefore, be placed at a safe
distance from flammable objects such as furniture,
curtains and similar objects.
-
Do not cover the fan heater.
-
Do not place the fan heater immediately under a
wall outlet.
-
Do not connect the fan heater using an on/off timer
or other equipment which can automatically switch
the device on.
-
The fan heater must not be placed in rooms where
flammable liquids or gases are used or stored.
- I
f an extension cable is used, it must be as short
as possible and must always be fully extended.
-
Children should be supervised to ensure that they
do not play with the appliance. The appliance in
not intended for use by persons (including
children) with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge.
If the appliance is damaged, do not use it any
more.
Special Safety Regulations
Model
Voltage / Hz Power
Rating
Settings
Temp
Fuse
requirement
Dims
Weight
PT-02-230
230V~50Hz
2,000
4 (OFF, 650W,
1300W, 2000W)
continuously
adjustable 0-85°C
10A
197x210x303
mm
4.2 kg
PT-033-230 230V~50Hz
3,300
4 (OFF, 30W, 1650W,
3300W)
continuously
adjustable 0-40°C
16A
250x250x390
mm
5.6 kg
PT-05-400
400V~50Hz
5,000
4 (OFF, FAN, 2500W,
5000W)
continuously
adjustable 0-40°C
10A
250x250x390
mm
6.6 kg
PT-09-400
400V~50Hz
9,000
4 (OFF, FAN, 4500W,
9000W)
continuously
adjustable 0-40°C
16A
350x440x480
mm
11.8 kg
To get the most out of your new fan heater, please
read through these instructions and the attached
safety regulations before use. Please also save the
instructions in case you need to remind yourself of
the fan heater’s functions at a later date.
-
Housing of steel plate and heat-resistant lacquer
-
Supplied complete with cable and plug
(9w may not include cable or plug).
Figure 1.
Fan Heater Dials
Function Selector with
three power settings
Thermostat Dial
copyrighted
document
- all
rights
reserved
by
FBC