Summary of EEC - 3000
Page 1
Owner's manual - eec 3000 grammable pro elliptical.
Page 2
- 1 - parts list key. Description q'ty key. Description q'ty 1. Main frame 1 28. Spacer x 49mm 2 2. Handlebar post 1 29. Spacer x 32mm 2 3. Handrail 2 30. Foam grip x 360mm 2 4. Connecting arm 2 31. Foam grip x 130mm 2 5. Pedal arm 2 32. 33 pu wheel 8 6. Holder 2 33. M8 carriage bolt x 70mm 4 7. Com...
Page 3
This owner's manual contains assembly, operation, maintenance and safety information. In the interest of safety, please make certain that you read and understand all the information below. Important safety precautions 1. Read the owner's manual and all accompanying literature and follow it carefully...
Page 4
Warning : before commencing with any exercise program, please consult your family physician. If at any time during exercise you feel faint, dizzy or experience pain, stop and consult your family physician. In the event any of the above mentioned warnings are breached by the consumer, the manufacture...
Page 5
Eec-3000 programmable elliptical assembly instruction step 2. Connect extension cable wire ( 8 ) with lower cable wire ( 9 ) then fit handlebar post ( 2 ) to the main frame ( 1 ) by using bolt ( 33 ), washer ( 44 ) , nut ( 46 ),then fit half moon cap( 47 ). Step 1. Fit feet caps ( 23 ) to the rear s...
Page 6
Step 4. Fit handrail to connecting arm ( 4 ) with bolt ( 34 ), washer ( 42 ) & nut ( 46 ). Be sure to tighten bolt firmly then fit half moon caps ( 20 ) on both ends. Repeat same procedure on assembling the connecting arm ( 4 ) & pedal arm ( 5 ). Repeat same procedure on the other side. Step 3. Inse...
Page 7
Step 5. Connect extension cable wire ( 8 ) & grip pulse wire ( 10 ) to the computer ( 7 ) then fix it onto handlebar post by using screws ( 39 ). Now the assembly of the programmable elliptical is done. Please note with the following information before use : 7 8 10 39 2 silicone spray warning keep o...
Page 8
8 3 0 2 6 4 3 5 0 3 6 1 5 5 0 1 4 3 2 7 5 0 5 0 2 0 3 4 4 2 4 2 4 6 2 0 4 2 8 5 0 5 0 3 1 0 1 1 3 1 1 3 2 6 1 4 2 4 7 4 6 4 4 8 1 5 5 0 2 7 5 0 2 0 3 4 4 2 5 0 2 0 2 7 5 0 4 4 2 1 3 5 0 5 0 4 6 4 6 3 6 7 3 9 - 7 -.
Page 9
16 27 50 38 29 41 44 49 20 58 42 46 57 55 32 35 56 20 36 42 49 27 45 40 5 6 9 37 45 12 24 12 18 17 21 22 45 48 33 25 24 19 23 23 1 38 16 29 20 58 42 50 27 46 57 55 32 35 56 5 49 41 44 36 20 42 49 27 6 45 40 eec3000-020121gb - 8 -.
Page 10
Operating information of exercise meter summary : this system is designed for programmable magnetic bike. There are 3 parts to this system, the monitor ( bc-6011ii ), motor & controller and magnetic braking system. Getting started 1. Monitor connections : plug the 10-pin connector (protruding from t...
Page 11
/ : a. During initial mode, use / buttons to choose your desirous profile or increase/decrease programmable settings (time, age & heart rate). Holding / for 1.5 seconds will change the settings faster. B. During exercise you can use / buttons to adjust the resistance setting select : use select butt...
Page 12
Prepare for your workout : before you begin, be sure that the power pack is properly plugged into a wall outlet and the low-voltage cable is plugged into the exerciser. 1. Press any key to initialize the monitor 2. Select "manual" or one of the 7 hill profiles using the / buttons and press enter to ...