Protex Prosecutor 2000 AVE-8002 Operation Manual - page 13
Power Cable
This is the gray cable with red and black wires on one end and a 4 pin connector on the other end. Verify the 4-pin
connector is connected to the vault in the trunk. Route the cable through the rear seat panel, under the back seat and
carpet, to the battery area of the car (routing through the firewall to the battery is preferred). Secure the red wire to +12
V (through the firewall to the battery is the best way). Connect the black wire to chassis ground.
Final Assembly
Attach the front camera to the camera mount and attach the camera cable to the control box. Also, attach the control
cable , interface cable and LED cable to the control box. Securing the cables out of sight in the headliner, mount the
control box to the back plate using the 2 screws that were previously removed. Secure vault to base plate and lock in
place. Verify cables are properly routed and are not pinched or in a bind.
Reinstall previously removed panel, trim, seats and other hardware. Reconnect car battery cables.
Power up the system
Attach completing the installation assembly, turn on the volume/monitor control switch. If the light on the POWER
does not turn on, check all the system connections and fuse in the power cable near the car battery. If the “POWER”
light is illuminated on the control console, the system can be turned on by using one of the following methods:
Control console activation - Press the “POWER” button on the control console.
Microphone activation - Place the remote microphone transmitter power switch in the “ON” position. The green LED
will illuminate on the microphone transmitter and the system will be powered up.
Power up the wireless receiver
The audio receiver powers up automatically when the power cable is connected to the battery and the control cable is
connected to the control console.
View of DB-25 and Power Cables coming
from trunk, positioned behind the rear
passenger side seat, heading toward
front passenger seat. Note: cables go
under carpet.
View of DB-25 located on front
passenger side, under trim, heading
upward toward headliner. Note: Power
Cable will go through firewall towards
battery.
View of DB-25 Cable, under headliner,
heading toward control console.
View of DB-25, Interface, LED,
Camera and Power Cables being
connected to Control Console.
View of camera being attached to
windshield mount. Note: Cable of
camera goes upwards into headliner.
View of control console being mounted with
wires already attached to connections
13