Protocol dronium III AP Instruction Manual - Charging The Drone Battery

1.  Make sure the drone is turned off.

2.  Open the battery cover and remove the battery.

3.  Connect the USB charging cable to the battery.

4.  Plug the charger into a USB port. The USB light will turn off while  

charging and will turn on once fully charged.

5.  Plug the battery back into the drone and close the battery cover.

CHARGING THE DRONE BATTERY

CAUTION WHEN CHARGING

1.  When charging, place product on a dry, well-ventilated surface and   

keep away from heat sources. 

2.  Always use adult supervision while charging.

3.  In order to increase battery longevity, avoid repeat charging and  

excessive discharging.

4.  As battery temperature is high immediately after flight, charge after   

cooling down for higher efficiency.

5.  Do not strike or subject battery to hard impacts or sharp surfaces.

6.  Do not use any other charger than that which is supplied with  

this item.

7.  Do not use or leave battery near a heat source such as fire or space  

heater; exposure to heat may result in reduced performance or in    

some cases dangerous conditions.

8.  If battery is left in charging state for an extended period of time after  

being fully charged, the battery may automatically discharge.

9.  Never leave the battery unattended during charging.

10. Do not disassemble battery.

11. Do not submerge battery in water.

Charging time: 120 minutes --- Flying time: approximately 7 minutes 

*Battery: Li-Po, 3.7V, 800mAh

If you purchased extra batteries, allow the engines to cool between flights 

in order to prolong engine life.

POWER-ON PROCEDURE

NOTE

1.  While the drone is in process of synchronizing or calibrating, the lights  

will flash quickly.  When the process is completed, the lights will go   

steady.  This is your indication that the process is completed.

2.  If after 30 seconds, it has not recognized the drone, turn off the  

controller and repeat Power-On prodedure.

3.  If the Dronium III is unsteady in flight, it may not have been able to  

calibrate properly.  Power down both drone and remote and restart   

pre-flight procedure, including re-calibration of the altitude sensor.

4.  For the Altitude Sensor to calibrate properly, the drone must be  

synchronized already, but the engines not spinning yet.  You cannot  

calibrate while the propellers are turning.  You have to calibrate before  

you start the engines.

Before flying, the drone and transmitter must be turned on in sequence and 

synchronized.  Once synchronized, you must press the calibration button so 

the Altitude Sensor can set properly.

1.  Turn on the drone and place it on an even surface.

2.  Turn on the remote control.

3.  Both indicators on the drone and the remote will flash while they  

are syncing.  

4.  Push the throttle up and then down to sync.  You will hear two beeps and  

the lights will go steady.

5.  Next, you must calibrate the Altitude Sensor.  Press the calibration button  

down once.  Lights will flash quickly and then go steady.  Your drone is  

now synchronized, calibrated, and in stand-by mode awaiting Engine  

Idle command.

6

7