Protocol Galileo Pilot's Handbook Manual - Camera
If the camera is not pre-installed:
1. Push the camera into the hold underneath the drone.
2. Plug the camera into the drone.
NOTE: Do not unplug or plug in the camera while the drone is on.
CAMERA
PHOTOGRAPHY/VIDEO INSTRUCTIONS
9
1. The memory card comes pre-inserted into the camera.
2. Turn the quad-copter on. The lights of the camera will flash and then become steady
green. If there is a red indicator on the camera, it means the memory card is not in the
camera. Insert the memory card and the red indicator will turn to green.
Shooting Video/Photo:
1. Turn on the transmitter and pull the throttle up and down to connect the quad-copter
and transmitter.
2. Photo: Push the Photo/Video button up and the camera will take a photo. The red
indicator will flash once and the remote will beep as it’s taking the picture.
3. Video: Push the Photo/Video button down and the camera will begin to record. The red
indicator will flash repeatedly and the remote will beep twice while recording video. Push
the Photo/Video button down again and the camera will stop recording.
4. Remove the memory card by pushing it in until it springs out of the camera.
5. Insert the memory card into the card reader. (Fig. 1)
6. Place the card reader into the USB port of your computer. The USB will come up on the
removable drive.
7. Open the drive and then open the Video or Photo folders to access the .AVI or JPEG
files.
8. .AVI movies can be played in several different formats including Quicktime, Windows
Media Player, and RealPlayer.
WARNING: Never remove the card from
the video camera while the helicopter is
turned on.
NOTES:
- All files on the card can be removed
or erased without compromising the
video camera
Fig. 1