Protocol VIDEODRONE FX Instruction Manual - page 6

1.  Make sure the drone is turned off.

2.  Open the battery cover and remove the battery.

3.  Connect the USB charging cable to the battery.

4.  Plug the charger into a USB port. The USB light will turn off while  

charging and will turn on once fully charged.

5.  Plug the battery back into the drone and close the battery cover.

CHARGING THE DRONE BATTERY

CAUTION WHEN CHARGING

1.  When charging, place product on a dry, well-ventilated surface and   

keep away from heat sources. 

2.  Always use adult supervision while charging.

3.  In order to increase battery longevity, avoid repeat charging and  

excessive discharging.

4.  As battery temperature is high immediately after flight, charge after   

cooling down for higher efficiency.

5.  Do not strike or subject battery to hard impacts or sharp surfaces.

6.  Do not use any other charger than that which is supplied with  

this item.

7.  Do not use or leave battery near a heat source such as fire or space  

heater; exposure to heat may result in reduced performance or in    

some cases dangerous conditions.

8.  If battery is left in charging state for an extended period of time after  

being fully charged, the battery may automatically discharge.

9.  Never leave the battery unattended during charging.

10. Do not disassemble battery.

11. Do not submerge battery in water.

Charging time: 60 minutes --- Flying time: approximately 7 minutes

*Battery: Li-Po, 3.7V, 380mAh

TURNING ON & SYNCING THE DRONE

NOTE

1.  If the VideoDrone FX and the remote do not sync after following the  

checklist, reverse steps 1 and 2 of the process.  Turn the remote and  

the drone off.  Then, turn on the remote first and then the drone.  

2.  Turn on the controller; if, after 30 seconds, it has not recognized the  

drone, turn off the controller to retry synchronization.

3.  If the VideoDrone FX is unsteady in flight, it may not have been  

able to calibrate horizontally.  Power down both drone and remote    

and restart pre-flight procedure.

1.  Turn on the drone and place it on an even surface.

2.  Turn on the remote control.

3.  Both indicators on the drone and the remote will flash while they  

are syncing.  

4.  Push the throttle up and then down to sync.  You will hear two beeps and  

the lights will go steady.

Tip: When syncing your drone keep it in a horizontal position for  

stable flight.

6

7