Contractor miter saw work station product manual 1 ws-077.
2 safety warning warning: be sure to read and understand all safety instructions in this manual, including all safety alert symbols such as “danger”, “warning” and “caution”, before using this power tool accessory. Failure to follow all instructions listed in the manual may result in electric shock,...
Miter saw stand rapid tool mount clamp mount adapter material support work stop material support receiver wheel axle plate handle knobs m8*35 1 pcs 2 pcs 2 pcs 2 pcs 2 pcs 2 pcs 2 pcs 1 pcs 1 pcs 2 pcs description qty part # parts list 3 13. Never stand or sit on tools. 14. Replace damaged component...
Safety instructions for miter saw stands 1. Use caution when folding or unfolding legs to limit any finger pinch points. 2. Place stand on flat and level surface to keep from rocking or tipping. 3. Make sure that work support extensions (if included) are within safe operating limits, and are properl...
Preparing the stand see figure 6 1. Lay the stand’s top surface down on the floor with the folded legs on top. 2. Press the quick release leg lock lever and rotate that leg up until the locking pin clicks into place. 3. Repeat with the remaining three legs. 4. Lift the stand and place it in an uprig...
6 attaching your miter saw or other bench top power tool see figure 8 various bench top tools can be used with your contractor miter saw work station by attaching them to the rapid clamp tool mounts. Always position the saw to achieve maximum balance and stability. All four corners of the saw must b...
Offset mounting see figure 9 offset mounting bracket for miter saws and/or power tools with an irregular mounting hole pattern. Instructions: secure offset mounting brackets as shown. Brackets can be used on the front or rear of the rapid clamp tool mounts. Note: if the saw has holes that do not lin...
To remove saw from stand see figure 11 1. Raise the locking levers to unlock the saw and tool mounts. 2. Lift away from the rear rail of the stand to disengage. 3. With the assembly tilted slightly toward you, lift the assembly to disengage from the front rail of the work station. 8 mounting the mit...
Transporting and storing see figure 12 1. Before storing or transporting, make sure all attachments are secure and bench top tool is removed. 2. Collapse legs and make sure they are locked into the up position. 3. Use the handle that is located on the end of the product for transporting. 4. Pull up ...
10 lifetime limited warranty protocol ™ contractor miter saw work station is backed by a limited lifetime warranty. This warranty covers manufacturer defects and workmanship. The warranty excludes misuse or abuse and normal wear and tear. Exclusion is not allowed in some states and may not apply. Th...
