Protovapor XPV DNA-40D Operating Instructions

Summary of XPV DNA-40D

  • Page 1

    Protovapor xpv dna-40d thank you for purchasing the protovapor xpv personal vaporizer. We hope this device will provide many years of enjoyment! Included in package u protovapor xpv personal vaporizer u usb-to-micro usb charge cable operating instructions charging never charge device unattended! 1. ...

  • Page 2

    4. The xpv should be almost fully charged upon deliv- ery from protovapor. It can be used immediately. General operation 1. Attach atomizer device containing e-liquid to the con- nector at the top of the unit. Do not overtighten! 2. To wake the device from power off state, tap the fire button. 3.. A...

  • Page 3

    “new coil? Up yes/down no”. When you see this prompt, if you have attached a new atomizer, push up. If you have disconnected and reconnected the same atomizer, push down. Display the normal and special operating modes shown on the display are discussed below. The dna 40d will auto- matically detect ...

  • Page 4

    To provide the desired wattage. The ohms too high message will continue to flash for a few seconds after the end of puff. Ohms too low: the resistance of the atomizer coil is too low for the current wattage setting. If this happens, the dna 40d will continue to fire, but will not be able to provide ...