Provape Provari Radius Owner's Manual - page 9
9
ProVari Radius Adapter
The ProVari Radius features a new standardized
thread (P3 thread) which allows the user to easily
switch between 510-style threads, Ego-type threads
and any new hardware equipped with properly
designed P3 threads. On the top of the 510 thread we
have added coin slots so you can tighten the
connector using a penny or dime. It's best to tighten
this connector so it does not come off when you
remove your tank.
Not only is the P3 thread stronger and more robust
than most other attachment systems available, it also
features specially designed adapters to allow the use
of virtually any atomizer, tank or cartomizer available
on the market today. By setting a new thread standard
with the P3, future innovations can be adapted for use
on the Provari as well!
Batteries
We recommend you only use IMR high drain batteries in this device. This will give you the full range of
output power needed to use the device. Only use approved batteries. Always feel free to contact us if you
are not sure which batteries to use. To ensure you get the correct batteries, you should always purchase
them from an Authorized ProVape dealer or online at
www.ProVape.com
. The ProVari Radius has the
ability to detect what type of battery you have inserted and if that battery is capable of providing adequate
power to the unit. If you use a poor quality battery, the ProVari Radius will reduce the output power to
match what the battery is capable of safely providing. If you plan to store the Radius for more than 10
days, we recommend you remove the battery or plug-in to charge. If the battery remains in the device for
more than 10 days without being charged, it will slowly drain to empty and this may damage the cell to a
point where it cannot be recharged.
The ProVari Radius operates on a single battery. Never stack two batteries.
Never use batteries that are not recommended for use in the ProVari Radius.
Never use magnets on your batteries as this is very dangerous.
Charging a Battery Using a Standard Battery Charger
Plug the charger unit into an appropriate power supply.
Insert a battery into the charger and make sure you put the battery in the correct direction.
Align the positive (+) end of the battery with the positive (+) mark on the charger.
The LED on the charger will glow red when the batteries are charging.
The LED on the charger will glow green when the batteries are charged.
(This could vary depending on the charger that you purchased)