Proview 562NS Series Service Manual - page 4

For Model 786NS,986NS Series 

WARNING :

This product included critical components which are essential for X-Radiation safety.  

See service manual for proper replacement.Maximum 2nd anode voltage must not exceed 

30KV at any operating conditions.  

To measure 2nd voltage use high impedance meter connect (-) chassis, use a high voltage  

lead from (+) to 2nd anode.  

For Model 572NS Series 

WARNING :

This product included critical components which are essential for X-Radiation safety.  

See service manual for proper replacement.Maximum 2nd anode voltage must not exceed 

27KV at any operating conditions.  

To measure 2nd voltage use high impedance meter connect (-) chassis, use a high voltage  

lead from (+) to 2nd anode.  

  VR501,VR601 has been sealed against improper replacement or defeating the control. 

                           Instructions for proper replacement of such sealed controls should also be provided in the 

service information. 

4