Provision ISR DI-390AHDE36+ User Manual - page 5
6
7
required accessories from the manufacturers. Issues
caused by unauthorized repair are your responsibility.
4.2 Installation Tools and Information
Prepare the required engineering data and instructions.
Before installing please prepare the following tools and
instrumentation: A straight or a Phillips-head screwdriver,
multi-meter, scissors, needle nose pliers, tape measure,
pencil.
4.3 Setting the Video Output Type
The camera supports AHD/TVI/CVI/CBVS video output.
Choosing the output type is done by setting a DIP switch
on the cable as illustrated:
4.4 Installation Method
1. Check if all equipment is in tact.
2. Mounting bracket or base:
• If you are installing on a cement wall, use the
expansion screw holes and then mount the bracket or
base.
• If you are installing on a wooden wall, use the
self-tapping screws to mount
3. Mounting the camera
a. Dome Camera
Adjust the lens position to aim at the monitoring points
and present a clear picture. Manually fix lens location
and adjust the hemisphere cover. Re-examine the
screen whether the character meets your requirements.
Tighten the hemisphere cover.
b. Bullet Camera
Adjust the body so the lens aim at the monitoring points
and presents a clear picture. Tighten the screws to
ensure camera will not move.
Installation method above is for reference only.
Note:
The wall needs to bear at least 3 times the
weight of bracket and camera.
ON
1
HD CVI Analog
AHD HD TVI
2
1 2
1 2
1 2
ON
ON
ON